1995 Pontiac Grand Prix Logo
Posted on Apr 05, 2009
Answered

I am removing the right front fender on a 96 pontiac grand prix

I am removing the right front fender on a 96 pontiac grand prix and have hit a rut. I cannot find any sort of diagram that shows me how to properly romove the fender if any one can find a site or copy of a diagram showing where bolts are and such please either post it or email me at [email protected]
thx
-ryan

Answer This Question

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.
Hot-Shot:

An expert who has answered 20 questions.
Corporal:

An expert that has over 10 points.
Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 37 Answers
  • Posted on Apr 05, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.
Hot-Shot:

An expert who has answered 20 questions.
Corporal:

An expert that has over 10 points.
Mayor:

An expert whose answer got voted for 2 times.

Joined: Apr 04, 2009
Answers
37
Questions
0
Helped
9925
Points
84

U NEED TO TAKE YOUR FINDERWELL OUT FRIST ON THAT SIDE THIN OPEN HOOD THE BOLTS R RIGHT AT THE TOP WERE YOUR HOOD FITS THE FINDER SHOULD BEE ABOUT SIX OR SO NOTE THE FINDER WELL IS THE UNDER NEATH PART OF YOUR FENDER U MAY WONNA REMOVE YOUR PARKING LIGHT FOR THAT SIDE JUST TO MAKE SURE U DONT BRAKE IT AND JUST BELOW THE MARKER LIGHT SHOULD BEE A FENDER BRACE REMOVE IT ALSO ITS LIKE A SHORT METTEL BAR ALL BOLTS SHOULD BEE 1/2 INCH GOOD LUCK AND RATE THIS PLEASE

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Can the front end parts( hood fenders ect) from a 2002 Pontiac grand am interchange with a 2001 grand prix
No, unless you really do some major modifications to them. It would look good anyway.. I think 99 to 03 works.Grand Prix only.
Read full answer
Dec 27, 2014 • Cars & Trucks
0helpful
1answer

How to replace front left fender on a 02 pontiac grand. Prix
Best to start by removing the wheel, then the inner plastic fender...held on with plastic push up tabs...remove all under hood fender bolts...probably 13mm...compare your replacement fender to confirm all necessary bolts to be removed, Is your new fender already painted?
Read full answer
Dec 26, 2014 • 2002 Pontiac Grand Prix
0helpful
1answer

My 1999 grand prix gtp was hit on the passenger fender and immediately shut off. vehicle will not start back up, acts as if its not gettin gas. how do i start vehicle or where is safety shut off switch...
Check the mass air flow sensor for damage or for loose wire connection.
Read full answer
May 22, 2011 • 1999 Pontiac Grand Prix
0helpful
1answer

How do you remove the dampner pulley on a 1998 potiac 3800 engine
  1. remove the right front tire and inside fender cover to see crank pulley.
  2. remove the belt, use a rachet to release the tension off the belt, i've enclosed a diagram of the belt and the tensioner.
  3. remove the center bolt on the crank pulley.
  4. using a puller remove the pulley.
  5. reverse directions to install.
  6. i hope this is helpful
    7. 4399c71.gif
Read full answer
Oct 31, 2010 • 1998 Pontiac Grand Prix
0helpful
1answer

How do I replace a 2005 Pontiac Grand Prix front wheel bearing. Do I need a press?
no its a bolt on, must remove wheel brake caliper and its braket then brake rotor, look at back of spindle you will see 3 bolts ,remove them and hit frt of hub until it comes out . good luck.
Read full answer
Oct 20, 2009 • 2005 Pontiac Grand Prix
0helpful
1answer

Wheel bearing torque
Front:
Mounting bolts 96 ft/lbs
Axle nut 159 ft/lbs

Rear:
Mounting bolts 55 ft/lbs
Read full answer
Sep 26, 2009 • 2001 Pontiac Grand Prix
4helpful
2answers

2001 grand prix starts and then dies right away
Check the fuel pump inline resistor located on the right side front fender between the frame and the windshield washer fluid canister. When this resistor goes bad those are the symptoms.
Read full answer
Apr 03, 2009 • 2000 Pontiac Grand Prix
0helpful
1answer

Car will start and only stay on for a few second.
i HAD THE SAME PROBLEM WITH MY 2001 GTP. REPLACED THE PUMP AND FILTER STILL A PROBLEM. FINALLY REPLACED THE FUEL PUMP RESISTOR LOCATED UNDER THE RIGHT FRONT FENDER, NO MORE PROBLEM.
Read full answer
Nov 16, 2008 • 1998 Pontiac Grand Prix
0helpful
1answer

Body work, pulling fenders off
Yep...see the link in the GP thread. The dude had to remove the hood bracket.

Thread bumper and fender removal
Read full answer
Jul 05, 2017 • 1997 Pontiac Grand Prix
0helpful
2answers

1985 grand prix
the oil sending unit is located on the front of the engine(this is facing the passenger side fender.) to access it take the front tire off on passenger side you will see the oil filter and a sending unit right behind and above it it will have a green colored plug. please rate this. thanks
Read full answer
Sep 23, 2008 • 2002 Pontiac Grand Prix
Not finding what you are looking for?

View Most Popular

1995 Grand Prix

  • Cars & Trucks

Related Question

Can the front end parts( hood fenders ect) from a 2002 Pontiac grand am interchange with a 2001 grand prix

  • Cars & Trucks

Related Topics

606 views

Ask a Question

Usually answered in minutes!

Popular Questions

My security light is on

2002 Pontiac Grand Prix

How to replace power steering pump

2004 Pontiac Grand Prix

Diagram on a pontiac grand prix

2000 Pontiac Grand Prix

Serpentine belt diagram 2005 grand prix 3.8l

2005 Pontiac Grand Prix

Routing diagram for 2007 pontiac grand price

2007 Pontiac Grand Prix GXP Sedan

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 1995 Grand Prix Manual

1995 Grand Prix

Loading...