Where is the map sensor located on a 1998 olds 88

Here you go copy and past then click on the first picture. It's number 5. https://www.google.com/search?client=ms-android-americamovil-us&ei=59KZWYn7DcPymQG4yoOIDw&q=1987+oldsmobile+delta+88+royale+brougham+map+sensor+location&oq=1987+oldsmobile+delta+88+royale+brougham+map+sensor+location&gs_l=mobile-gws-serp.3...4920.20339.0.21667.21.21.0.0.0.0.406.5585.0j1j16j2j1.20.0....0...1.1j4.64.mobile-gws-serp..1.17.4932...0j0i22i30k1j33i22i29i30k1j33i160k1j33i21k1.dB-spKCclH4

Mass airflow senor po102 is probably defective between tbi and air box

I don't list a map sensor being used on a 1987 Olds with the 3.8 engine. It should have a MAF sensor instead.

Its on the top of the BLACK PLASTIC going to your air filter..IT will be 2 inches by 3 inches with 1 plug and 3-4 screws holding it depending on engine size.....Make sure when you remove it to get the hole cleaned out sometimes the old map sensor breaks the plastic off.

Hi at the end of your air cleaner tube is a square box with 4 screws and a plug in it. This is your map sensor

In the duct of the intake,in the fire wall of the back

I have a series II 3.8 liter. The MAF sensor is located under the plastic cover for the engin. You have to take the oil fill cap and neck off to lift the cover off. Once the cover is removed, the MAF sensor can be seen at the top and to the left of the engin. it is a small square box that has a three wire plug in and two vacume lines going to it. Ceck to see if the wire connections are ok before you replace the sensor. Good luck.

your engine doesn't have a MAP (Manifold absolute pressure) sensor it has a MAF (Mass Airflow) sensor, that is located in the air intake hose to the throttle body of the intake.

map sensor located on firewall right side of vehicle..3 wire connector..small black sensor..with a vacuum hose leading to it..throttle position sensor on right side of throttle body unit..3 wire sensor..iac located on front of throttle body..4 wire sensor

THE MAP SENSER IS VERY EASY!!!!!
Its on the top of the BLACK PLASTIC going to your air filter..IT will be 2 inches by 3 inches with 1 plug and 3-4 screws holding it depending on engine size...VERY EASY GIG....Make sure when you remove it to get the hole cleaned out sometimes the old map sensor breaks the plastic off...
ANSWERED BY GARY KNOWS ALL