2000 Dodge Neon Logo

Related Topics:

Anonymous Posted on Jul 31, 2013

How to buy dodge neon 2001 serpentine belt - 2000 Dodge Neon

  • Anonymous Aug 02, 2013

    for more detail, i mean buying it by some part number or something like that

×

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Jul 18, 2008

SOURCE: serpentine belt diagram:

The belt routing diagram is located on the top radiator cross member by the hood latch. You should see it when you open the hood. If it is not there, all Chrysler, Dodge, and Plymouth minivans, from 1993 to at least 1999, used the same 3.3L engine setup, so find someone with one and look for the diagram where I described.

Ad

Anonymous

  • 6784 Answers
  • Posted on Aug 24, 2009

SOURCE: diagram for a serpentine belt replacement for 2000 avenger dodge

HI. i have posted the diagram requested below.

7109f62.jpg

Testimonial: "This was exactly what we needed, Thank you so very much. "

Anonymous

  • 1959 Answers
  • Posted on Oct 18, 2009

SOURCE: how to install alternator belt 2001 Dodge

Below is a diagram for the belts on your car. You will see to the right, an adjusting bolt. This loosens the tension to slide the belts on and off. Once the new belt is on, apply pressure to get the belt tight (a long flathead screwdriver or crowbar should do) and while tight, re-tighten the adjusting bolt.
da5dc36.jpg

Patrick Rayome

  • 1757 Answers
  • Posted on Jan 22, 2010

SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan

3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!

Anonymous

  • 277 Answers
  • Posted on Nov 23, 2010

SOURCE: I need a serpentine belt diagram for a 2001 Dodge

Hope this helps

dak408_64.gif

Testimonial: "That was both quick and easy Thank You"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2001 dodge neon timing belt

http://technoanswers.blogspot.com/2012/02/how-to-replace-timing-belt-on-2001.html
1helpful
1answer

Serpentine belt routing diagram for 2004 dodge neon

over p/s pulley,down to a/c pulley ,up to crankshaft pulley ,under tensioner pulley
0helpful
1answer

How do you replace serpetine belt on a 2001 Dodge Neon

You need to locate the tensioner pulley.Need to pull tensioner forward.There will be some resistance.If you can get that forward the belt will come right off. Just remember the belt route when you do it.
0helpful
1answer

Aircondition compressor froze up 01 Dodge Ram 1500

You will need to buy the no a/c belt most likely. Check the diagram in the engine compartment.
1helpful
2answers

Where is the water pump on plymouth neon engine.

Hello mark_mack...The Neons water pump is an internal part which is powered by the timing belt. For installation all the accessories, belts, timing cover and motor mount has to be removed. Then the serpentine belt, the lower crank pulley has to be removed. The water pump is behind it and can be replaced in five minutes...just takes awhile to get to it. I would not recommennd doing this job without the knowledge and proper tools.
Note: this would be a good time to replace the timing belt as well, since you already have it removed.
Good luck..i hope this helps..please rate me a fixya.
1helpful
1answer

How do you remove and replace the AC/PS drivebelt

Click on the following free direct Link. It has the correct Serpentine/Drive Belt Diagrams for your 2004 Dodge Neon 2.0L SOHC Engine with AC and PS. Included are Instructional and Directional Diagrams on "how" to remove the AC/PS Belt along with other very useful Diagrams for your use.

http://www.2carpros.com/car_repair_information/year/2004/make/dodge/model/neon/2004_dodge_neon_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!
Not finding what you are looking for?

241 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...