Question about 1999 BMW 318 ti

1 Answer

BMW 318I WONT START.

Hi, my bmw 2001 n42b20a engine has no spark and no fuel cuming to the cylinders, but fuel is in the injection system, and is stopping it from starting. No eml lights on dash either.please help

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 250 Answers

Sounds like crank sensor

Posted on Sep 05, 2009

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 16 Answers

SOURCE: replace ignition lock cylinder 1996 BMW 318i with 1995 BMW

no you can not

Posted on Mar 12, 2009

Anonymous

  • 112 Answers

SOURCE: engine misfire and some times does not start when cold

Replace the Oxygen sensor. All your trouble codes are downstream of the oxygen sensor, and are related to it.

Once you replace the oxygen sensor (replace with a BOSCH sensor!), remove the positive battery cable, step on your brakes for 10 seconds, then reattach the cable. This will clear the codes from your ECM (Electronic Control Module).

Posted on Mar 26, 2009

bmw_tech_38

mark brown

  • 113 Answers

SOURCE: BMW 1999 318i eml light come on whilst driving.

The EML light will come on if you have an emissions fault , the car may drive ok but you may find you are using more fuel , it would be better to get the problem checked just to be on the safe side , regards mark.

Posted on Aug 13, 2009

Charles Hunter

  • 107 Answers

SOURCE: my 318i bmw 4 cylinder has hard start on cold morn...

possible air mass meter fault or split concertina air hose between airr flow meter and manifold

Posted on Jul 19, 2010

astrawoid

Eric Cross

  • 294 Answers

SOURCE: hi i have a 318i bmw 2001 my fuel consumption is

Last month, my wife complained of high gas usage as well. I suddenly remembered that I had forgotten to change the air filter the last time I did the oil change. It had been over 5 months since I'd put a new one in. So, we got a new air filter, and monitored the usage, and it was back to normal again. Maybe try this?

Posted on Dec 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine jerking


Most probably u have a spark plug coil gone bad or a spark plug wires.
But if not then then go through the following:-
  1. Check fuel filter or clean system
  2. Faulty or incorrectly gaped spark plugs
  3. Defective spark plug wires .
  4. Emissions system components faulty.
  5. Low or uneven cylinder compression pressures.
  6. Check as described in
  7. Weak or faulty ignition coil(s).
  8. Weak or faulty ignition system.
  9. Vacuum leaks at intake manifold or vacuum hoses .
  10. Dirty or clogged fuel injector(s). .
  11. Leaky EGR valve.
  12. Fuel injection or engine control systems malfunction.
I know it is along list but going through them will make a peace of mind to know which area is week and which is faulty.
Hope this Helps.

Apr 05, 2014 | 2000 Ford Excursion

4 Answers

1999 BMW


you have to get the fuel pump checked.

Jul 08, 2008 | 1997 BMW 328

1 Answer

1994 CHEVROLET C1500 PICKUP 4.3L V6 vortek cranks no start backfiring thru the Throttle body fuel injection system. The Distributor has a small hairline crack under the reluctor wheel could this be the...


100 psi per cylinder is way too low--should be in the vicinity of 150-165 per cylinder
back firing indicates wrong firing order and as you have replaced the plugs etc check that you have the leads on the correct plugs in the correct order
the timing for the engine should be around the 10 degree btdc and not tdc

Mar 23, 2017 | Cars & Trucks

1 Answer

Code po 491 and po 492


P0491 Secondary Air Injection System (Bank 1)
P0492 Secondary Air Injection System (Bank 2)
Good luck for you!
OBD2 code reader

Jun 25, 2013 | 2001 BMW 330

1 Answer

DODGE DAKOTA 2001 ENGINE STALL


Sounds as if you may have a vacuum leak; possibly a dirty/sticking idle air control valve, or dirty/sticking EGR valve. Could possibly be clogged converter or muffler as well.

Feb 12, 2018 | 2001 Dodge Dakota

2 Answers

Dose a 2000 taurus lx have a single or dual port fuel injection and is the coil pack for one cylinder or is it a pack for all cylinders?


depends on the type of engine. DOHC engine has coil on plug ignition system where the OHV has a coil pack with spark plug wires going to it. Both engines only have one fuel injector per cylinder.

Jul 13, 2011 | 2000 Ford Taurus

1 Answer

Misfire low fuel on start cylinder 5, 6


While the engine is running pull the spark plug wires on one cylinder at a time (assuming you can do so safely). When you pull a write you should notice the engine stutter, if you pull one and nothing happens that cylinder had a spark problem and you should change the plugs and wires, all six, even if only one doesn't respond.

Jun 07, 2011 | 2001 BMW 325

2 Answers

Ford mondeo 2001 has misfire and wont tick over


Do a tune-up or clean your spark plugs.

Sep 07, 2009 | 2001 Ford Focus

1 Answer

4 cylinder motorbike engine won't stay running. Fuel is injected in. The sparks are all working. It will start running sometimes and only keep going with near full throttle which will hold engine at less...


If its cable throtle then clean throtle hosing on the inlet manifold.If that does not work clean the injectors.By adding fuel treatment for injection systems.Or remove and get them checked out.

Jun 03, 2009 | 1999 Plymouth Voyager

1 Answer

Engine misfire and some times does not start when cold


Replace the Oxygen sensor. All your trouble codes are downstream of the oxygen sensor, and are related to it.

Once you replace the oxygen sensor (replace with a BOSCH sensor!), remove the positive battery cable, step on your brakes for 10 seconds, then reattach the cable. This will clear the codes from your ECM (Electronic Control Module).

Mar 26, 2009 | 1999 BMW 318 ti

Not finding what you are looking for?
1999 BMW 318 ti Logo

Related Topics:

1,109 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Doberman

Level 2 Expert

261 Answers

auntyjack

Level 2 Expert

104 Answers

Roy Cunningham

Level 1 Expert

35 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...