1999 Pontiac Bonneville Logo
Anonymous Posted on Jul 14, 2013

How to replace the high low switch in a 1999 pontiac bonneville

I am trying find out how to put the new high low switch I bought in my Bonneville to replace the one that does not function so I will have head lights.

1 Answer

Stephen

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Pontiac Master 21,873 Answers
  • Posted on Jul 14, 2013
 Stephen
Pontiac Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jun 22, 2012
Answers
21873
Questions
0
Helped
6209801
Points
67230

Should be mounted on the top of the steering column with a rod going up to the turn signal switch.

5 Related Answers

Anonymous

  • 611 Answers
  • Posted on Jun 15, 2008

SOURCE: 2000 pontiac bonneville wiring harness

u can get one to use out of a srvice book at the libruary

Ad
pkthoege

Paul Thoegersen

  • 95 Answers
  • Posted on Nov 19, 2008

SOURCE: bonneville ignition cylinder replacement

get new cylinder look at it and see the spring loaded tab you need to push in. Now pull the steering wheel column lock plate (gm tool required unless you have super thumbs) pull out key buzzer switch , roll key over to unlock wheel, press the same area on the lock cylinder to release it

Anonymous

  • 379 Answers
  • Posted on Dec 30, 2008

SOURCE: 1999 Pontiac Bonneville serpentine belt installation.

if you look by the crankshaft pulley to the right you will see a tubular looking shaft about 1" diameter , you will notice you can't get the belt out from under this piece , it has a nut on it , once you take the nut off , you will notice it has a star shaped point on the tip of the stud , it requires a reverse torx socket or wrench to remove the stud , when you get the stud out the tube piece it can be removed , then the belt comes off , replace the belt , now comes the tricky part , fitting that tube spacer back into its spot , it can be difficult , once its in place put the stud back in , and put the nut on and tighten it , your pretty much a pro now . thanks.

Anonymous

  • 3600 Answers
  • Posted on Nov 01, 2009

SOURCE: My 1999 Pontiac Bonneville will not start. When

The security system has been activated call the dealer to getthe deatils on how to reset it, normally you pull the security fuse for 30 seconds to restet it. if that does not work call the dealer and they can help you.

Anonymous

  • 388 Answers
  • Posted on Nov 05, 2009

SOURCE: I have a 1994 Pontiac Bonneville SSE.. won't start

It sounds like you have a short somewhere that is draining the battery...this type of thing is usually caused by a faulty voltage regulator. I recommend taking the alternator to an autoparts store to have it tested...don't be surprised if the alternator tests good; a faulty voltage regulator can and will drain a battery in a matter of hours. I am including a link where you can order a voltage regulator for your Bonneville or, while you are at the autoparts store, you can buy one there. The link will help you to see what the voltage regulator looks like so you can identify it in your engine compartment. Hope this helps, good luck!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Why do my heat only blow on low in my 93 bonneville sse

this is usually due to the switch wearing out, replace switch or remove switch and put jumper wire straight from 12 volt supply to the high terminal, if you prefer to have high, switch is typically 12 dollars and easy to replace.
0helpful
1answer

94 pontiac bonneville starts and idles fine put it in drive to go and it bogs down real bad

When I put my 1996 Pontiac Bonneville in drive it will rev high when i go to take off but it barely gains and speed. What could cause that.
0helpful
2answers

Where is the blower resistor located on a 1999 pontiac bonneville

Go to any autoparts online store such as autozone and you can look up any part replacement step by step. May have to register.
0helpful
2answers

How many cans of freon should i put in me 95 pontiac bonneville

None, unless you know how much is already in it. what are you high and low pressures? what is the ambient temp? what is the vent temp? Leave it to a pro. Fix the leak. then have it recharged with the correct amount.
0helpful
1answer

Will a 1997 pontiac bonneville transmission work

THAT CAN BE THE CASE, THE GEAR RATIO CAN BE DIFFERENT, JUST AS THE REAR WHEEL DRIVE CARS, AND YOU NEED TO BE CAREFUL. THE ELETRICAL CAN BE DIFFERENT ALSO, GET THE SAMME YEAR, MOTOR SIZE.
3helpful
2answers

My 1999 Pontiac Bonneville will not start. When

The security system has been activated call the dealer to getthe deatils on how to reset it, normally you pull the security fuse for 30 seconds to restet it. if that does not work call the dealer and they can help you.
0helpful
2answers

Turn signals don't work but hazards do on 1995 bonneville pontiac

Hi,

Try Check or replace the turn signal switch. It might have loose connections or its faulty.
0helpful
1answer

How do i change low beam lamp and parking light for 2000 bonneville

the whole light assembly comes out in one peice. there are two bolts located on top of both ends of the assembly (silver in color)
Not finding what you are looking for?

104 views

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...