Locate starter how to take off

Starter Motor Removal

1. WARNING: WHEN SERVICING STARTER MOTOR (11002) OR PERFORMING ANY MAINTENANCE IN THE AREA OF THE STARTER MOTOR, NOTE THE HEAVY GAUGE INPUT LEAD CONNECTED TO THE STARTER SOLENOID (11390) IS HOT AT ALL TIMES. MAKE SURE THE PROTECTIVE CAP IS INSTALLED OVER THE TERMINAL AND IS REPLACED AFTER SERVICE.
   Disconnect the battery ground cable (14301). Refer to Section 14-01 .
   

1. Raise the vehicle on a hoist. Refer to Section 00-02 .
   

1. Disconnect starter cables from starter solenoid.
   

1. Remove upper and middle bolt.
   

1. Remove lower bolt and starter motor.
   

1. Position starter motor to engine and install middle and lower bolts finger-tight.
   

1. Tighten the upper bolt to 20-27 Nm (15-20 lb-ft).
   

1. Tighten the lower and middle bolts to 20-27 Nm (15-20 lb-ft).
   

1. Connect starter solenoid connector. Be careful to push straight on and make sure connector locks in position with a notable click or detent.
   

1. Install S terminal cable eyelet with washer and nut. Tighten to 4.5-6.5 Nm (40-57 lb-in).
   

1. Install starter cable nut to starter solenoid B-terminal. Tighten to 9-14 Nm (80-124 lb-in).
   

1. Replace red starter solenoid safety cap.
   

1. Lower vehicle to floor.
   

1. Connect battery ground cable.