How to reset warning lights on toyota highlander 2009

SOURCE: reset oil maintenance light in

1. Set the "ENGINE START STOP" or engine switch OFF with the trip meter A reading shown.
2. While pressing the trip meter reset button, set the "ENGINE START STOP" switch or engine switch ON.

1. Continue to press and hold the button until the trip meter displays 000000.

1. Continue to press and hold the button until "COMPLETE" appears on the multi-information display.

SOURCE: Computer warning Oil maintenance 2008 Highlander Hybrid

Please email me on [email protected] and I will email you the procedure in printed matter.

Cheers

SOURCE: How do I turn off tire pressure sensor warnning

set the tire pressure to the door decal, check all the tires, including the spare.

SOURCE: How do I reset the maintenance warning light on

To disable this light without unplugging the battery:

1. Start the car.
2. Place odometer on Trip A
3. Turn car off
4. Place your finger and hold the odometer trip button
5. Turn key to the "on" position while holding the trip button; not "acc"
6. Wait until the computer reset finishes
7. The maint reqd light will turn off

steve titus

• 277 Answers
• Posted on Jul 18, 2010

SOURCE: 2003 Toyota Highlander clock resets when I turn off the ignition

Have you checked any fuses? Does the climate control light up? If not then in the under hood fuse box (left of drivers side) check the ECU-B fuse should be 7.5 amp. Check the heater fuse in the fuse box inside the car it should be 15 amp. If the fuses are OK and only the clock is bad check out my site www.autoclockrepair.com I offer a repair service.