A symbol on my dash board...

Sounds like your Sentry Key Immobiliser Module may be at fault. That's a Main Dealer Problem. Try disconnecting the battery lead for a minute or 2 then reconnect. Red.

jeep Stratus? are you in the wrong forum?

Problem with 1999 Jeep Grand Cherokee??????? I overhauled a 2.7l stratus 2003 it wont start it turns over / -----------------------------------

did you check for spark?
and check fuses yet>
is the CEL lamp in the dash glowing key on telling you EFI is ready to start or if car has immoblizer is that lamp stuck on?

i see you lost your operators guide. in the glove box?>
it is an engine, and is called the CEL or mil (or ses)
the CEL is the CHECK engine light.
it glows , running, to tell you that the ENGINE brain, (PCM)
sees serious errors, or outright failures.
it also says in the missing opr. guide , to get car serviced.
on your car, we connect a universal OBD2 scan tool to the 16pin
dash port, and scan the PCM.
and see all those errors.
takes about 5min. work.

may auto stores, state side, do this for free.
or loan a full tool to do advanced testing, and analysis.

Hi. Thanks for your question. For issue related to jeep cherokee laredo you can visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams for better understanding. Good day!

Replace the turn signal switch. They started running all the lights threw it. They call it the multifunction switch now.

this configuration of light usually depicts a door is open or ajar. this could be caused by a door switch, the hood switch, the hatch switch, even your gas cap door might cause this to come on.
i would say that a proccess of elimnation would be the best course to take. start with one door open it and push the switch by hand untill you find the switch that makes the dash light go out.

if the doors when opened turn on the interior light and turn it off when closed the switch on these doors is good. these switches are either located in the door jam by the hinges or on the very end of the dash board.
the hood switch when you open the hood should allow the light on the bottom side of the hood to come on. pushing down on the switch should turn the light off.
this procedure should help you locate the problem switch

Also check brake switch adjustment, it is the interrupter.

the problem is with the bulb, what is happening is when you push your brake pedal with the lights off you are turning on you parking light side of you bulb, when the lights are on the parking light is already lit up so when you push the pedal you see no change. try a new bulb

I don't know why , but you can reset the check engine light by disconnecting the postive battery cable only and wait 10 - 15 minutes and then reconnect this will rest your light, if there is a real problem the light will come back on, otherwise it was just a minor emission problem and correct itself.




Melvin
St Louis

The red ( ! ) symbol right? It might be a burnt out fuse, or the E-brake cable isn't connected.