Auto trans truck shifts hard and pops out of gear

Auto Trans not shifting correctly from 2nd to 3rd - Ford Explorer ...

www.explorerforum.com > ... > Under the Hood

May 8, 2004 - 19 posts - ‎9 authors
Auto Trans not shifting correctly from 2nd to 3rd Under the Hood. ... Become an EliteExplorer. Lithuania. 1999 5.0. Join Date: Jun 2003. Posts: 107 ... When this happens, the transmission will skip to the next gear like you said.

Transmission Harsh shifting - YouTube

? 3:59
https://www.youtube.com/watch?v=aAoiL4vR8Qw
Jan 13, 2013 - Uploaded by James Burns
... Doctor, explores the causes of harsh shifting in automatic transmissions. ... Early diagnosis is important to ...

Hard Tranny Shift between 2nd & 3rd - Ford Truck Enthusiasts Forums

www.ford-trucks.com > ... > Super Duty & Heavy Duty

Feb 24, 2012 - Hard Tranny Shift between 2nd & 3rd Super Duty & Heavy Duty. ... I just got a new to me 99 f250 5.4 V8 SD XLT 4x4 Auto Trans longbox 118k miles. ... it out and said it was solid except for a hard shift between 2nd and 3rd gears. ..... Hard shift between 2nd and 3rd, Brenda Lamka, Explorer, Sport Trac, ... hard shift 2nd to third gear only 4r100
Dec 26, 2012
hard shift into 3rd
Nov 4, 2009
4r55e 5r55e Ranger / Explorer Transmission Problems - CLICK ...
Mar 15, 2007
00 Expedition trans shifts late and hard

Most likely you have a linkage problem between the shift lever and the transmission and or the rubber bushings for that linkage are bad. It can also be the pivot point of the shift lever.

Have you checked for auto transmission fluid level? It needs to be Mopar ATF +4 ONLY, no other brand will work correctly. Check for major leaks. Check tranny for tranny codes NOT cel codes.

When you shift into park and if Park holds then the trans is gone. (Auto clutch packs burned up) Smell for burned fluid. Pull up the trans dipstick with the car running and warmed up. Make sure the level is good. Most likely a trans Overhaul is needed.

does it lock up in any gear? sounds like blocking rings trying to stick, what type oil did you put in it?
should take auto transmission fluid

It is slipping and about time for a rebuild
I would guess it is not the first trans in there after 20 years

There are a few possible causes of this: Likely internal shift synchros in trans have worn out. Possible: linkage worn, or bad input shaft bearing. In all cases trans will need to be removed and torn down.

sounds like ur sencanizers r broke

Is there a check engine light on at all?

shifts off electric servo controlled by cars computer , see trans guy you can trust could need service ,oil and filter changed or part , like i said see one you can trust .