Check engine light on

just take off battery lines from battery pole for 15 minuts ...then ligth turn off

See here p68, p222, p282, p329

http://www.turboninjas.com/camry/eg2.pdf

That's a lot going on! If those are real errors, you could spend some time and money fixing it. May not be too hard, but if you have an electrical gremlin somwe here causing the problem, then that could be a pain to fix.
If clearing the code for inspection is your goal, you could look into an OBD2 bluetooth scanner to work with your phone. I use one along with Torque for Android. I can check and clear codes with my phone, but I do 95% of my maintenance myself.

The P1135 code on your Toyota is Air fuel ratio sensor - heater circuit malfunction. Basically the problem there will be with the air/fuel ratio sensor (on other vehicles it is refered to as an O2 oxygen sensor), or the wiring/connectors leading to it. It could also be a problem with a fuse or relay on the heater circuit. Again, not a real difficult problem to solve.

just fixing the P1135 code will not cause the check engine light to stay off because there are other unrelated codes. If the code P1135 was causing the other problems then perhaps fixing that code would fix the others, but that's not the case here. The reality is you'll need to have all the problem areas looked at (IAT sensor, MAF sensor, Air/fuel ratio sensor) and repaired in order for your engine light to stay off. Normally if there are codes stored a vehicle cannot pass inspection. I would get a second opinion from another local mechanic as what you've been told may not be 100% correct.

Good luck.

P1135. Air/Fuel Sensor Heater Circuit Response. (Bank 1 Sensor 1).

The P1135 code on your Toyota is Air fuel ratio sensor - heater circuit malfunction. Basically the problem there will be with the air/fuel ratio sensor (on other vehicles it is refered to as an O2 oxygen sensor), or the wiring/connectors leading to it. It could also be a problem with a fuse or relay on the heater circuit. Again, not a real difficult problem to solve.

Now, to specifically answer your question. I'm not familiar with the inspections in New Jersey, however just fixing the P1135 code will not cause the check engine light to stay off because there are other unrelated codes. If the code P1135 was causing the other problems then perhaps fixing that code would fix the others, but that's not the case here. The reality is you'll need to have all the problem areas looked at (IAT sensor, MAF sensor, Air/fuel ratio sensor) and repaired in order for your engine light to stay off. Normally if there are codes stored a vehicle cannot pass inspection. I would get a second opinion from another local mechanic as what you've been told may not be 100% correct.

Good luck.

anyone knows the solution for Camry Engine code 440. I reset at half tank of gas & then filled upo the tank. Engine Light came back exactly on half tank again.

P0125- Engine not reaching operation temp quick enough. Possible problems:

• Insufficient warm up time
• Low engine coolant level
• Leaking or stuck open thermostat
• Faulty coolant temp sensor
• P1130- A/F Sensor Circuit Range/performance, Bank 1 Sensor 1

25 means the thing is saying it's running lean. all the check areas, however, are not for the home mechanic to play with.

You need to reset the light with a scan tool, the same one you used to read the code in the first place.

http://www.obd-codes.com/faq/reset_obd_codes.php