How can I pull off the spark plug wire tip in a 1991 Toyota previa. Pliers don't work because of the lack of space. please heeelp
SOURCE: 1991 toyota previa 132,000 ml.
I had a power problem, when cold idled just fine,when warm it would miss at idle, spudder on acceleration and sound just fine at higher rpm. found number three spark plug wire had burned through lower boot. Spark was firing to head at low idle. same wire burn twice with about 40000 mile between.
SOURCE: how to change spark plugs in 02 toyota tacoma v6
You need a special tool when they are stuck on, it's like a long pair of neddle noise plyers with sides that grabs the wire by the boot evenly, but twist them loose from the plug as you pull the rubber actuaully melts itself to the plug sometimes
SOURCE: 2000 toyota 4runner pulling a random misfire in
try a new crankshaft sensor not hard to change 2 bolts and a wire
SOURCE: car wont start, not getting spark
crankshaft sensor, or computer on toyotas then it was usually the distributor or the computer, but the crankshaft sensor might be bad too thats what helps to get you spark.
SOURCE: How to replace dash light bulb of 1991 Toyota Previa Van
pop fuse cover, remove vent housing, remove speedo upper cover, remove 4 bolts holding speedo remove speedo, change bulb
90 views
Usually answered in minutes!
×