At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Hi,welcome to fix ya. That light is there to remind you its time for service . it starts out flashing then when the service is past due it stays on solid . heres the reset procedure
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you didnt change them 1 by 1, did you. oops...
see the FSM for this, by engine type
or alldata.com
this engine?
2.5L (G25A4) Engine Firing order: 1-2-4-5-3 Distributorless ignition system
front of car.
engine
coil pak( 4,5,C.3,2,1)
rear fire wall
possible you have to reset antitheft mode ,is there a red light flashing when you turn key to on possion not starting it ? some will reset by putting key in drivers door and turning it open close 3 times look for lights to flash then try to start.
Somehow it is effecting the TPS (Throttle position sensor) This is the only input to go to third to fouth and not seeing the proper gear change VSA light appears.
the maintence reminder lamp means you are due for oil and filter change.to reset maintence light, turn the ignition switch to the on position engine off.push the reset button on clock control panel for 3 seconds,then turn off ignition switch.then turn back on the ignition switch the maintenance light should be off is so.it has reset.
Press odometer reset/adjustment shaft in, hold in and turn key to run position. Keep holding in the reset shaft in for about 30 seconds. release shaft. turn key off. restart car. Service Light should go off in about 5 seconds.
Key off, hold select and reset button, then turn key on, but don't start engine, wait approximately 15 seconds until maintenance required light stops flashing. Turn key back off. Turn on again without starting if reset is successful maintenance light will only appear once.
×