When do you change water pump and engine sealsin V4 2006 Honda accord?
Is coolant leaking at the water pump?
Not that I know of, but I will be driving about 50 m to work each way and my husband thought it might be good to change water pump & engine seals since my car is at 90,000 miles. It has a chain, not timing belt.
Usually the timing chain will last as long as the engine and on your water pump,I would leave it alone,when was the last time you changed the anti freeze and radiator cap and flush the radiator.Also check your belts,they need changing with that mileage,normally 60 miles .
Sorry I meant 60,000 miles on the belt changes.
×
SOURCE: 1999 Honda Accord Coupe
See an example
DISASSEMBLY
1.
Remove the suction pipe and the O-ring from the oil pump.
2.
Remove the rear cover with the gasket and pins.
3.
Remove the cam ring.
4.
Remove the rotor and vanes.
5.
Remove the front side plate.
6.
Remove the inner and outer O-ring.
7.
Remove the spring.
When assembling, use a new gasket and O-ring.
8.
Remove the pulley nut with the spring washer.
9.
Pull off the pulley and the woodruff key.
10.
Remove the snap ring using snap ring pliers.
11.
Drive out the pulley shaft with the bearing. If necessary, use plastic hammer
SOURCE: location for a 92 honda accord fuel pump
its not in the gass tank the fuel pump is under the hood
SOURCE: 2000 Honda Accord's Timing Belt and Water Pump
sounds like your timing belt is a little to tight and the vibration from the belt is the humming you here
loosen the belt but you may want to call the dealer for the spics on tightness of the belt . thx
SOURCE: inatallation 92 honda accord power steering pump
Hey, here's the procedure, disable air bag, if equipped w/ one, disconnect the pump return hose from the reservoir and place the end in a large container. Plug the port in the reservoir. Start the engine and turn the steering wheel lock to lock several times, until fluid stops running from the hose. Turn off engine immediately. Re-attach hose. Disconnect the inlet and outlet hoses at the pump. Remove the drive belt. Remove the mounting bolts/nuts and remove pump.
Install in reverse order. Adjust belt tension,fill ps reservoir and bleed any air from the system (to bleed air from system, fill reservoir, start engine and allow to idle, turn wheel from side to side all the way several times. Shut off, fill if necessary.
. Tighten bolts to : Thru bolt 30 ft lbs., mounting nut 16 ft lbs.
SOURCE: replace water pump on 1994 honda accord lx
the water pump is run by the timing belt.so behind the timing belt cover!
259 views
Usually answered in minutes!
×