I Have A 98 Mercury Villager. And, It Just Died, While Driving Home 6 Days Ago. It Will Not Start Back, Won't Do Anything. So, I Removed The Starter to jump test it from a car battery. The Bendix Spins Fine, Like Its Okay. But...The Bendix/Cylinder Does Not Slide Pop out into the crank shaft to turn over the Engine. Is The Bendix/Cylinder Supposed To Raise??
Yes, the starter drive should pop out so it can engage with the flywheel teeth
SOURCE: Car running rough when raining
check the spark plug wires, put water in a spray bottle and spray along the wires,especially by the coil,if the car starts to run bad or you see sparks, the wires are no good, hope this helps, Ray
SOURCE: 94 mercury villager wont start
power on the small terminal of the starter solenoid when you turn the key?
SOURCE: My 1998 Mercury villager van 6 cylinder 3.0eng keeps cutting off
it could be faulty fuel pump or coil pack transistor.
SOURCE: my piston 6 miss fire.
Could be a lot of things,
Check spark plug wire
Spark plug
If those are good, get a compression test done to see how the cylinder is.
You could also have a bad fuel injector, which will not deliver fuel.
129 views
Usually answered in minutes!
×