1993 Ford Probe Logo

Related Topics:

Posted on Mar 15, 2009

My 93 ford probe gt wont idle and wont shift outa 2nd gear

It starts and then dies out if i push on gas it stays running when i come to a stop it dies out. and it wont shift past second gear rpm's just go up car speeds up but wont shift gears

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 6 Answers
  • Posted on Mar 08, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

Joined: Mar 08, 2010
Answers
6
Questions
0
Helped
2386
Points
14

Sounds like you need to check your vaccum lines for a leak. This is easy to do. Buy a can on carburator cleaner and with a friends help keep the car running as you spray your vaccum lines with the carburator cleaner one by one. If you have a leak it will **** the cleaner into the lines and cause the vehicle to stall out. Replace the line if this happens and continue checking all lines until all bad lines are replaced.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

89 ford probe hesitates when leaving a red light, then runs fine otherwise, fuel filter?

Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard ...

repairpal.com > Problems > Ford > Probe
Ford Probe Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard Starting, Poor Performance. This is a verified problem based on 9 reports. Learn more ...

Starting Problems - 1997 Ford Probe - RepairPal

repairpal.com > Questions > Ford > Probe > 1997 Ford Probe
Dec 5, 2010 - Starting Problems on 1997 Ford Probe ... If the engine runs rough,stalls, hesitates on acceleration, is hard to start, or has generally poor ...

A new misfire/hesitation on accel. Problem.. - ProbeTalk.com Forums

forums.probetalk.com > Tech Section > 2nd Gen (93-97) V6 2.5L
0helpful
1answer

1995 Ford Bronco engine dies when shifted into drive but runs in reverse or 1st gear

Could be fuel filter,air filter,tune up,wires,coils.low idle too low.
0helpful
1answer

Manual shift light blinks, chugs when accelerating.

Hi Seth, Check out your engine and gear box mountings! Regards John
0helpful
1answer

93 probe gt wont start please help!!!!!!

I suspect the fuel pump has gone,sorry.
0helpful
1answer

Car dies at stop, or down-shifting into second gear.

try turning the idle screw counterclockwise. #5 in the pic below.
0900c152802664f5-qoourh23u0mln3qht2iy2cfx-2-0.gif
1helpful
1answer

In my 1996 ford probe GT the stick shift will move where ever it wants to but my car is stuck in 2nd gear. It wont allow me to change gears but the stick shift can literally move in a full circle. I feel...

Hi I am stuck in 2nd too.But I have a Probe 1989 GT and shifter will not move. I am told I need to tap/hit some rods in the tranny, after I remove about 10 bolts on the side of the tranny, and this would unstick it. Could work for yours too. I did see someone ask "what if the shifter moves? then its more of the shift gates, and is easy to fix. I not see answer to how, tho.
0helpful
1answer

IM installing a turbo on a 93 ford probe gt and i

ran it without oil stoped shut it off now it wont start it cranks all day but dont start
0helpful
2answers

1994 Ford Probe GT standard transmission - Will not shift into first or second while car is running. Shifts fine while car is off.

Check your slave cylinder Usually located below the brake master cylinder. If there' Fluid you probably need a clutch.
4helpful
3answers

1995 cadilac deville has problem shifting from 1 to 2 gear

You don't have torque converter shudder. You don't even mention that in your original post! You def had a solenoid issue. My 94 STS did the same thing. I only had reverse, 1st and 2nd gear. Wouldn't shift outa 2nd period. It was a $200 solenoid repair. Car had a 160K on it when that happened. I have almost 170k on it now. Shifts and works fine. you don't need the tranny replaces ad josavv63 indicates.
Not finding what you are looking for?

506 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...