How do i change a break light in a 89 buick electra?

Do you mean when you put it in drive the car does nothing, if that is what you mean to say then you only have one thing wrong that causes this, the transmission has failed (this assumes the fluid is not really low)

Here watch this video

http://www.youtube.com/watch?v=kt2fvHlzv-4

Make sure you replace both your rotors & pads. Don't just replace one side.

you don`t say where they keep breaking.if its around the bolts then you can use a thicker washer this might help.if the tracking system that the seat slides on then if there is room you might be able to weld a re-enforcing plate to the system where it cracks to stop it.

Should be a bayonet mount which requires a 1/4 turn to the left.

Its hard to say really it could be a number of things.

From my experience, id almost always go tot he power antenna first. This things always break stick bind etc and when they do they cause a nasty battery drain.

drop the fuel tank (make sure u have 2 new straps, old ones alvays break) chaNGE PUMP AND CHANGE FILTER AS WELL

the trans filter is internal.raise & support vehicle.fluid is drained by removing transmission pan.this can get messy.trans pan gasket & filter are usually sold as a set.fill W/new fluid through dipstick tube.note that trans will not need as much fluid as is listed in specifications--torque converter will not drain.if you change your own oil;this is the next step.

look for rear wiper fuse and relay.because both circuits is tie together . look in glove compartment for the manual .it will show where all fuses and relays located.

yes you will you will have to take side trims and sill panel off get a 10 mm ready and take the bolts out the tail liaghts should come out the license lamps have screws in them and if you looka t them but you should be able to twist bulbs and pull them out / Please rate my response thank you very much

need a diagram for the order the spark plug and pannle wires go.