Need to remove bumper of 2000 Honda Accord Coupe

Need to remove exhaust and rear cradle with suspension in order to remove the tank, I've done a few in the last year cause the tanks were leaking.

Remove bumper only the side u need,bolts or plastics clips on top, two or three under the radiator support for bumper, remove head light, under the fender by the end of the bumper is a bolt for the bumper and other for the fender, 4 bolts on top, one bolt inside bi the door hinge, one or two in the bottom under the side plastic skirt .

This video will show you how to change the headlight in your Accord.">

i think that you might have either a bad head gasket or a cracked head,only way to tell is to remove the head and send it to a machine shop to get it magnafluxed.

What would you like to know before proceeding with this procedure???

Review the repair manual Honda-Accord-Coupe-Section-10-Body

I hoep help you. Good luck (remember rated this help).

easy there is a screw on both sides were bumper and fender meet just pop back fender liner its a phillips head. Then pop hood remove clips on black trim infont of radiator. Underside where bumper goes under car remove those clips and 10mm bolts after all is removed bumper just pulls off ...... may have to give it a hard **** a few times but it will come off. Should only take 15-20min to remove if its your first time

first i wanna say good luck too you..I don't know who dizayn that head light assmebly but it was the stupidist think i ever seen..
My friend 1992 accord had a broken head light and he asked me the favor and i thinked just the headlight why not...
first i had to remove front grill and side marker find one bolt under side marker but it dosent change anything then i figure it out whole think!!!!!
You have to remove whole bumper cover and bracet to remove bottom screws 3 on inside 2 on out side of head light...
i have to spend hours to replace 40 bucks head light..

Its easy look at the bottom of the bumper has retainers and the fenders have a bolt on each side then just slide off

hi you have to remove the bumper but not a big job as it is only the cover a screw under each wheel arch three clips in the middle and a set of clips and ten millimeter headed bolts yates210456