SOURCE: trying to replace a front headlight bulb on 2001 acura 3.2 TL
Look for the end of the wire retainer clip. Unhook it and lift it up. Remember not to touch the bulb. But if you do, just clean it with a bit of alcohol.
btw - Here's a bit of info from a previous post of mine...
The low beams consist of three parts. The bulb, inverter/ballast and
the ignitor. The bulbs usually start to loose their color long before they burn out.
The inverters/ballasts either go out after a while or take a while to
start up.
Before you spend money on a new bulb, try swapping it with the one on
the other side. You'll need a security torx screwdriver to get the
covers off of the back of the lights. Don't touch the glass bulbs. If you do, just clean them with a bit of alcohol.
If the problem stays on that
side, try swapping the ignitors. They're mounted inside the black
covers.
If the problem is still on that side you've got a bad inverter. They're
mounted on the bottom of the headlight assembly. You'll need to remove
the front bumper and remove the headlight assembly to get to it. (I
recommend you take pictures as you remove things so can put them back
together correctly.)
SOURCE: 1997 Acura TL Airbag Control Module removal
First of all removing of radio will definitely give you alot more room. (rememeber you will nee radio code after you unplug radio) I would recommend that you disconnect battery before you EVER work on air bags. This module is pretty simple to remove but it is help by Special TORX screws. after removal of screw it its a yellow latch to pull across and unplug. Good luck thanks for using FIX YA
SOURCE: how to remove door panel on 1997 acura tl
Follow this link. There is detailed step-by-step info here
Please kindly let me know if it works for you
Good Luck
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008c18d
SOURCE: how do i change the cabin filter in my acura 2009
The advise by Techbuster was a bit off. The '09 is a bit different than the earlier models. To change the filter, pull the center divider in the glove box straight forward. The cabin filter housing in immediately behind it. Push the two clips on the outer edges inward and slide the tray out. Replace the filter, reinsert the tray, replace the center divider.
SOURCE: resetting air bag light on a 2009 acura tl
First you need the SRS System Diagnosed for
problems
That is why any check light comes on
Assuming you had the car repaired,then the shop
should have turn off the light, as well as a though
road test.
There is no resetting or turning off of ANY MIL Lamps,
as you just remove what data is stored & needed to
repair any vehicle.
If the codes are cleared, they will come back along with
the light
To see if the light will return or the problem wasn't an
issue is a waste of time & lack of system knowledge
Accept the fact that at least once a year with todays
technology,you will have check lights & expensive repairs
That is here to stay forever
241 views
Usually answered in minutes!
×