Hi
I know on my commodore it has a code that I can enter I need to access this by using the buttons on the dash that are used for checking fuel level till empty, distance to go, distance travelled etc.
Could be the same for you worth a try problem is you need the code for your car.
Most are factory set at 0000 but you only get a couple of goes.
Regards Craig
SOURCE: flashing maintenance required light
NEEDS AN OIL CHANGE. YOU CAN RESET IT YOUR SELF. HOLD IN THE "TRIP" BUTTON AND TURN THE KEY ON (DO NOT START IT) 5 DASHES APPEAR AND DISAPPEAR 1 AT A TIME THEN 5 "0"'S AND YOUR DONE. SOMETIMES THEY HAVE TO BE ON "TRIP A" BEFORE YOU START
SOURCE: 1995 Mercury Grand Marquis electronic Dash goes blank
Possibly bad wiring with the tow package added on. Almost like it was not installed properly or that the lines where crossed or it was setup to a wrong fuse and it is popping eveything and making this happen
SOURCE: anti-theft system
You have to have 2 keys that are already programed in order to program another key. The procedure is cycle 2 programed keys in the ignition switch one at a time pausing 3 secs each time in the run position or until the antitheft light proves out.Then cycle an un-programmed key for 3 secs and the same for any addition key.It will have a limit of 8 keys.
If you do not have 2 already programmed keys then you have to have a scan tool that will perform security access and key programming.
SOURCE: park assist off
just diagnosed this problem at work, if you can, get the truck scanned, it will give you a code, if you can reply with a DTC code i can tell you what's wrong
92 views
Usually answered in minutes!
I have locked and unlocked with both keyless remotes and also the keypad, thanks
Have you tried locking/unlocking the car with the keyless remote? How about the keypad, if you have one?
×