HI, Drivers-side door latch does not work from the outside. I took the door panel etc apart and found that the pin that disengages the latch does not descend far enough to do what it needs to do. When I press down on the pin manually I can disengage the latch. So my question is, what's the trick to fixing this??? I don't see any obvious adjustment that's going to resolve this. Any and all help is appreciated. Thanks, Tom
SOURCE: 1994 regal custom door
R/F door trim will have to be removed. Most likely you will find linkage disconnected from the inside latch of the outside door handle. You might even find a broken piece of the door handle requiring replacement
SOURCE: Volvo v70 1999 tailgate won't open
I had the same problem on my '98 V70 - my rear liftgate would not open. The "rear lift door open light" was on. I guess it was some kind of electronic problem in the locking mechanism. But it could have been something else like the metal bar that extends from the outside handle down to the mechanism had slipped off (unusual design seems like it should be connected instead of just sitting on a plastic latch handle) or maybe it was bent because this car had been hit in the rear as I found out looking around in there. Anyway, I took off the interior panel and inside handle. There was a large torx bolt that had to be removed if I was going to replace the mechanism. I later found out that there were two more once I got the gate open. I took a photo of the way everything was connected so I would have a record just in case I needed it. I bought a new lock mechanism. There is a thin piece of plastic down near the bottom on the mechanism that somewhat blocks a screwdriver or other tool from reaching in and opening the door that way. So I had to start removing things. I disconnected the power first. I removed the two screws I could reach which let the part that was connected to the connector be removed out of the way. I removed the metal bars that went from the outside door handle and the lock down to the mechanism. I still couldn't reach where I needed to. So since I had the part I began to slowly break away pieces from the mechanism. They are plastic so they broke off without much trouble but it did take a little work. Finally I reached down to the thin plastic part I referred to earlier that covers the part that unlocks your liftgate and pulled it enough off of it to get access to the release. One last try with a screwdriver let me push the actual release and the door opened! There was much rejoicing. Then I removed the old and replaced with the new. Reconnected everything checked and rechecked. It's working so far. That's how I did it.
SOURCE: 2000 lx 470 driver door panel
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
84 views
Usually answered in minutes!
×