- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This is a hub and bearing assy. You will need to remove the axle nut, brake rotor, caliper assy. There are 3 or 4 bolts that attach the hub assy to the knuckle assy. Most of the time, the hub assy will come out easy and sometime it comes out very hard. Make sure you torque the axle nut to the proper spec, so the bering will not fall apart and will last. Buy a quality hub and bearing assy, so you dont have to do it again.
Open the rear deck. There are two phillip head screws holding the tail light assembly, located just inside the rear deck jam. remove them, then gently remove the TL assy. The sockets twist out CC. Then you can replace the bulb. Look at the socket to see if it is black ( burned ). Common on the WS. Hope this helps. TJ
go to our villager site for help. The wiper motor has a governor assy, that is what you are referring to. What is the problem?
Windshield Wiper Governor
Removal
The windshield wiper governor (17C476) is located on the LH side of the engine compartment behind the battery (10655) .
Remove the two windshield wiper governor screws and the windshield wiper governor .
Disconnect the two windshield wiper governor electrical connectors.
The bolts can be replaced 1 of 2 ways w/o pulling axle. Need to take rotor off and either press bolts out with an arbor press or can be tapped out with a copper or brass hammer. Once out, the new ones can be pressed in by putting about 4 or 5 washers on and then tightening the lug nut down until the lug is pulled snug into the roter. Once snug, the roter can then be reinstalled on the wheel and brake assy put back. Caution!! Brake assy needs to be supported up out of the way with wire or coat hanger while removing rotor. Undo force of weight on brake pad assy can damage hose or unit itself.
×