2001 Ford Taurus Logo

Related Topics:

A
Anonymous Posted on Aug 22, 2017

2001 mercury sable driver side brake lockes up

Had problem with front brakes hanging up and causing steering wheel shake. replaced front rotors and pads, hoped it was just old parts. upon replacement found driver side caliper hard to compress. post replacement driver side brakes locks up after several braking attempts. when locked opening bleeder screw driver caliper relieves lock condition, so does leaving the car sit for awhile.

1 Answer

S Sigs

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

  • Ford Master 406 Answers
  • Posted on Aug 22, 2017
S Sigs
Ford Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

Joined: Nov 02, 2015
Answers
406
Questions
0
Helped
126901
Points
2933

Bleed all of your brake lines.

5 Related Answers

Anonymous

  • 353 Answers
  • Posted on Jun 24, 2009

SOURCE: left front brake caliper locked up, what causes

the small rubber boot around the piston is either off or has a hole, which let water in and rusted the piston to the cylinder

also can be caused by a hot caliper submurged in water

Ad

Anonymous

  • 432 Answers
  • Posted on Sep 06, 2009

SOURCE: The front passager side brake got locked frequently. Wheel is hot

If you open the brake fluid bleeder on that caliper you should have brake fluid dripping out. If not it could be the rubber flex hose has collapsed.If fluid drips out then the caliper is sticking and should be rebuilt or replaced.

Testimonial: "In five months I've replaced the caliper twice, and the new one is only 3-days old. When I installed the new caliper I checked bleeder. looked good."

Anonymous

  • 10319 Answers
  • Posted on May 03, 2010

SOURCE: Repeat issues with drivers side front brake caliper

Were the lines to the brakes completely flushed out? If not have that done. Contaminates in the fluid id common and will bind the pistons in the brake calipers causing premature wear to the brake pads
If the pistons are sticking they will need to be removed and the inner piston wall cleaned thoroughly. Rebuilt calipers are much easier to replace if rebuilding your own is not an option you want to take

Anonymous

  • 2559 Answers
  • Posted on Dec 06, 2010

SOURCE: 2001 F450 rear brakes lock

Sounds more like the rear wheel bearings may be the real issue.

Anonymous

  • 90 Answers
  • Posted on Jan 29, 2011

SOURCE: Brake on front passenger side continuously locks

Replace the brake hose. An internal tear in the hose can allow fluid to flow into the caliper, but collapse inside not allowing the pressure to release.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What makes it shakes

Sounds like bad brake pulsation, meaning warped rotors. When rotors are warped , they push the caliper piston in and out ,causing the brake pedal to pulsate and shake the steering wheel. I would start with replacing the front pads and rotors, and if you have drum brakes in the rear, have those cleaned and adjusted for a more balanced braking system.
0helpful
1answer

199 mercury sable.steering wheel shakes when applying brakes but no vibration in the pedal.

I would check the Rotors and see if they need to be turned Have you check to see how much brakes are left?
1helpful
1answer

Front tire shakes when stepping on brake pedal

Front brake rotors can warp in heavy use. When it becomes warped it'll cause the steering wheel to shake when brakes are applied.-----------------------------------------------------------------------------
Tacho Pro 2008
1helpful
1answer

Shaking front wheel when braking. Mecury Sable 2001 front wheel drive

If the front wheel shakes only when you apply the brakes, the most likely cause is a warped brake rotor. The rotor can be "turned" to make it flat and true again, but it will most likely warp again since it will be thinner and it gets hot when you apply the brakes. I normaly replace them and they are about $35.00.
0helpful
1answer

How do you get the capierer pin off to put front brake pads on my Mercury Sable LS?

Section 06-03: Brakes, Front Disc 1999 Taurus, Sable Workshop Manual REMOVAL AND INSTALLATION Brake Shoe and Lining Removal
  1. Remove brake master cylinder filler cap (2162). Check fluid level in brake master cylinder reservoir (2K478) . Remove brake fluid until brake master cylinder reservoir is half full. Discard removed fluid.
  1. Raise vehicle on hoist.
  1. Remove wheel and tire assembly from front disc brake rotor mounting face. Use care to avoid damage or interference with disc brake caliper (2B120) , front disc brake rotor shield (2K004) or front wheel knuckle (3K185) .
  1. Remove rear brake pin retainers (2N386).
  1. NOTE: It is not necessary to disconnect hydraulic connections.

    Lift disc brake caliper from front disc brake caliper anchor plate (2B292) and front disc brake rotor (1125) . Do not pry directly against metal caliper piston or damage will occur.
  1. NOTE: To prevent damage, do not allow disc brake caliper to hang by the front brake hose (2078) .

    Position disc brake caliper out of the way.
  1. Remove inner outer brake shoe and lining (2001) assembly from front disc brake caliper anchor plate .
  1. Inspect both rotor braking surfaces. Minor scoring or buildup of lining material does not require machining or replacement of front disc brake rotor.
-----------------------------------------------------------------
remove the 2 pins, #10 in pic. Usually has a dust cover over pin accessopening. Usually torx haed or hex head bolts (pins).


snorkelbobby_7.gif
0helpful
2answers

1995 Ford Taurus shaking when hitting the brakes

sounds like spindle/axle may be bent!
0helpful
3answers

When i brake my steering column shakes, what could cause that

Warped front brake rotors. Do you feel a pulsating in the brake pedal as well? If so, this confirms it.
0helpful
1answer

1997 Mercury Sable thumping in front end

try to replace the wheel bearings.
1helpful
1answer

Car Shakes

Certainly sounds like a partially, or seized caliper hanging up, which has warped rotor. What exactly did they replace at brake job, do you know? Either way they need to be rechecked.
0helpful
2answers

Brakes

hello , it sounds like maybe you need to have your car alimement check .
Not finding what you are looking for?

193 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...