The dashboard lights to my Sebring will not come on, I have checked fuses and such and no luck.. Would it have to be with the cluster? and how do i access that to check?
SOURCE: 1997 town & country stalls intermittently. ...
I had the same problem in the past with the lights. I repaired it by removing the the dash panel and re-soldering the pins where the harness plugs into. I am currently having the stall issue. in my research it seems to be the crank shaft sensor. I was told that the crank shaft sensor and the cam sensor work together and have decided to change them both along with the gas filter.
SOURCE: 1995 chrysler sebring lxi
there are four 18mm bolts on the opposite side of dust plate.once u remove thoe bolts,you'll have to either use a slide hammer, or the old fashion way a big hammer and smack it side to side.the whole hub and wheel bearing assembly will come out.The dust sheild is in between the hub and axel once it comes apart u will understand.
SOURCE: instrument cluster bulb is out. how do i replace
It may not be a bulb, as the instrument cluster usually has a number of bulbs and they probably didn't all blow at once. Pulling instrument clusters can be touchy and may not be for the average "shadetree mechanic" however, typically there are a few screws above the cluster going into the dash pad and a few hidden behind the trim panels below the cluster.
SOURCE: 2001 Chrysleraudio Sebring LXi Coupe audio system noise
There is probably a feedback (noise)filter connected somwhere near the coil. the are usually a cylindrical metal filter about the size of a double a battery,usually have a single wire connecting them,there may be one for each ignition coil,the will usually burn the wire when they are bad,not always. hope this helps.
466 views
Usually answered in minutes!
×