2000 Chrysler Sebring V6 oil pressure light comes on when oil is warm. Replaced the seals and value cover and still the light comes on while Idel now drops below 5 rmp

Here is how I fixed the low oil pressure light problem without using any parts, only the labor to remove the oil pressure sensor is needed. I have an 02 seabring convertible 2.7L engine and I was having the same problem with my oil light coming on at an idle. I bought a new sensor replaced the old one and had the same problem. I than got a test kit and tested my oil pressure. It was very good, never lower than 11 PSI hot at an idle. I was reading about the wire connector modification, but I had an 02 and this mod came out in 98, surely Chrysler incorporated this mod on its newer vehicles. Well after checking more they did not and this is what turned me off on Chrysler products forever. For a manufacturer to produce a vehicle with a known defect and a modification fix and not incorporated this modification on its newer vehicles is inexcusable. After reading that the modification was to stop pressure build up in the sensor housing I decided to make a pressure release hole in the sensor housing. I took my old oil pressure sensor and using a 1/8 inch bit I drilled a small hole at the base of the plastic sensor tower. I put the old sensor in and drove for a week, no problem with my light coming on. To test further I took the new oil pressure sensor I bought and drilled a hole in it. Put it in and I've been driving for months and no problem with my oil pressure light coming on now.

This maybe what is going on with your car. Here is something from Wikipedia, but if you Google it you will find 100's of hits. This is a common problem.

Oil sludge or black sludge is a solid or gel in motor oil caused by the oil gelling or solidifying, usually at temperatures lower than 100 degrees Celsius. Sludge can be a major contributor to Internal combustion engine problems, and can require the engine to be replaced, if the damage is severe. Sludge is usually caused by the presence of water in the oil, and can accumulate with use. Ways to minimize sludge production and accumulation includes performing frequent oil changes, using synthetic oil, and following the manufacturer's engine maintenance routine.
The following engines were reported by the Center for Auto Safety and/or their manufacturers to have a problem with sludge accumulation:

• 1998-2002 Chrysler 2.7 L LH V6
  • 2001-2002 Dodge Stratus/Chrysler Sebring
  • 1998-2002 Dodge Intrepid/Chrysler Concorde

You need to check your oil pressure with a gauge, if its not up to par you will need engine work. sometimes its only the oil sending unit but you need to find out by checking the pressure