After i replaced the new c v axle on my 1989 camry, i decided to pull it out. but wont come out, the reason why i want to pull it out again when i drive the car the c v axle that i just installed its making loud klicking noise specially during acceleration. what should i do to get it out?
SOURCE: subaru cv axle noise?
Do you know if this car has ever been recked? if your going thru that many axels makes me think something is not running true, a wheel bearing would not make a cv joint in a axel go bad. Did you replace the axels? or did you have them done at a shop, and did you see the old axels after they were replaced. You got bigger problems than a wheel bearing. From what i can gather some thing is bent or your getting bunch of bad axels witch i dought.
SOURCE: '93 camry left drive axle replacement problem
the c clip is down u must remove and reposition the openning down
SOURCE: Loud squeaking noise during cold start + Very long acceleration
if its carbureted, it needs a carb adjustment
as far as the squeal, its most likely the belts
SOURCE: 85 cj7 rear axle removal
Do you have bolt in axels? or are they held in with C- clips? If its bolt in axels you need to remove the bolts, and you may need an axel puller to get them out. If its got C- clips rear cover on rearend has to come off, and pin has to be removed to get C- clip out to get axel out.
SOURCE: 1999 Toyota Camry makes noise when accelerating.
Look at the drive belts on the alternator and airconditioning to see if on of them is too loose...
48 views
Usually answered in minutes!
×