2000 Toyota ECHO Logo

Related Topics:

Timmy Posted on Apr 05, 2013

My lights on chime does not work on 2000 Toyota Echo

There is no chime or alert when I leave my lights on and the keys are removed.

5 Related Answers

Anonymous

  • 318 Answers
  • Posted on Jun 22, 2009

SOURCE: toyota echo 2000 - airconditioner belt squeaking

well the belt could be loose or the compressor may be seized.....or the belt may be old and squealing.

Ad

Anonymous

  • 73 Answers
  • Posted on Sep 22, 2009

SOURCE: Remove and clean Toyota Echo heater fan.

The fan is under the pass dash, remove the glove box and you should see it, 1 plug and 3 8 mm screws.

Testimonial: "Thank you very much."

Anonymous

  • 438 Answers
  • Posted on Oct 14, 2009

SOURCE: How to....remove radio sepakers (rear) from a Toyota Echo??

It's really easy to remove the rear speakers. First, get in the trunk and find the 3 white anchors for the rear deck-they're near the rods for the trunk mechanism. Push them through the metal frame to free the deck. Next, you have to get in the back seat and remove the stop light from the deck. To do this, push in the pins on the locking mechanisms on either side of the light to free the back casing. Pull the pins out and the casing off. Next, undo the two bolts holding the stop light in place and pull it off-don't forget to undo the wiring harness. Next, find the three anchoring points for the back seat. Gently lift the two side ones free of their anchors. This gives you access underneath the deck. Free the deck and gently lift it over the seat. You'll have to jimmy it a little to get the locking clamps free--they're all along the back of the deck. Pull it free and you have access to the speakers. I believe the factory speakers are 5 1/4 inches
Try to use Toyota speaker adapter plugs so you don't need to cut wires and mess the electric system up. You can get them from Ebay or Amazon.

cheers

emaletrent

  • 19 Answers
  • Posted on Oct 18, 2009

SOURCE: how to remove toyota echo car stereo system

remove stereo suround which is held in with some stubbin clips then its quiet easy from there

Anonymous

  • 4399 Answers
  • Posted on Mar 06, 2011

SOURCE: Which is the fuse to

Usually the fuse box has the diagram. Does yours?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

'Key in ignition' chime will not stop when door is open

You have a problem with the switch in the ignition responsible for sensing ignition key, the switch is stock on.
0helpful
1answer

2000 toyota echo door

It depends on the actual problem. A body shop may be able to use a tool to go down thru the window sill to unlock the latch. If the latch is damaged, you may have to cut into the door to remove it.
0helpful
1answer

Does the 1999 Echo have a body control module? Are the BCMs and ECUs the same unit or two separate units?

- Connect the pins 4 (CG) and 13 (TC) with a paper clip or automotive wire, keep open the driver's door and leave the ignition switch ON for 30 minutes.
- After 30 minutes, switch OFF the ignition, remove the jumper wire and start the engine.
0helpful
2answers

Replace headlamp unit on 2000 Toyota echo

How do I replace the headlight Assembly on my 2000 Toyoto Echo?
0helpful
1answer

1999 Ford Taurus Se with U engine. When turning car off and removing the key, the oil and ABS light are still illuminated, also the chime to alert you that the key is in the ignition chimes. I solved the...

Well if the ABS light is still on when you turn the car off you might want to check the brakes especially if you have drums in the back. check the oil level too. also the oil pressure guage might be bad along with the abs sensor.
0helpful
1answer

Airbag light is blinkin on mine 2000 toyota echo

Hey,
take a look at www.airbagmodul.com

They're working in Airbag-Simulators and Occupancy Sensor-Simulators.

Regards

Gerrit
4helpful
1answer

2000 Ford F250 SD V10 has an alert chime that upon starting up the motor beeps three times pauses, then repeats. Does this maybe 5 times then stops. What is the problem or alert about. No idiot lights...

key on engine off, does the airbag light illuminate then go out? or never seen? this is usually that the air bag light is not functioning as should so gives you an audible warning......
1helpful
1answer

Red light with key emblem fashes

The red flashing "Key" indeicates that the factory security system is active. The light is a diode, and consumes very little battery power. The light alerts potential theives that the vehicle has an anti-theft system installed and active. Hoe this helps, and Thanks for choosing FixYa.
2helpful
1answer

Need programming instructions for RKE for 2000 Mazda 626

2000 Mazda 626
Note: Make SURE the battery is new.
Instructions for programming ONE keyless remote fob.
1. Open the driver’s door & leave open.
2. Insert the key in the ignition.
3. Turn the key to the on and off position 3 times.
4. Remove the key from the ignition.
5. After door open chime stops, press the door open button 3 times.
6. After chime, press any fob key twice.
7. After second chime, press any fob key twice again.
8. After third chime, press any fob key twice again.
9. Press the door open button once.
10. The car should give another acknowledgement chime.
11. Test key fob.
This DOES work. I just programmed mine successfully today, three hours ago.
Not finding what you are looking for?

111 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...