When i bought it the people befor me replaced the alternater and bypassed the factory computer now I can't get it to charge right or run right...they also had lots of sound and t.vs. in it ....I have replacedthe alternater again my self but can't figure out why its not recharging....
Trouble shooting required:
What voltage is do you get with a multi meter at the battery terminals when the vehicle is running. (looking to see the alternator is putting out the required voltage)
What voltage when it is not running & during cranking. (testing the quality of the battery)
Does the battery go flat overnight? What if you disconnect the battery overnight? (Looking to see if something is draining the battery when the vehicle is not running)
SOURCE: 2000 Jeep Grand Cherokee Elec fan won't run
you will need to change your fan relay which is located behind the front bumper on the passenger side
SOURCE: change a serpentine belt on 04 jeep grand cherokee laredo
Check this link & scroll down to your engine. Click on picture to expand.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528004328a
SOURCE: 2000 Jeep Grand Cherokee Laredo Door Locks Dont' Work Correctly
you need to check wiring between lf door and body..peel back rubber boot and pull on wires..you will find 1 or more broken wires..can be repaired
SOURCE: 1995 Jeep Grand Cherokee Laredo - sunroof leak
lift rubber edges and apply clear silicon sealant under edges let cure hose with water to test, if leak then seal edges of glass with eurothane sealant, not silicon will rot in sun within year
SOURCE: My 97 jeep grand cherokee makes a chirping sound under front
The noise and the light may or may not be related. The noise may be the wear indicator on the brake pads touching the rotor (they are supposed to do that when brakes are worn) The abs light triggers off a wheel on the axle end. If you have a bad joint on the axle, it could be noisy and causing the wheel to not have the proper clearance to the abs sensor. You really need to take the wheel and brake assembly off and carefully inspect everything. Make sure all abs sensor wires are undamaged...it doesn't have to be at the same wheel that's chirping.
Testimonial: "Thanks so much, this makes sense I will have it checked out right away. I really appreciate your help."
108 views
Usually answered in minutes!
×