Question about 1995 Chevrolet K1500

1 Answer

Hole in bottom of engine?

1995 k1500 suburban. chevy 350 engine The guy I want to buy this truck from says his mechanic told him there is a small hole in the bottom of the engine, but I can't seem to find anything to prove this. No leaks and it sounds fine. I know the manifold gasket needs to be replaced but thats all I have found so far... Any idea what he might have meant?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 141 Answers

Might have been a dishonest mechanic or just a simple error.
Make sure oil level is good, run engine until warm, park on newspaper or other absorbent surface. check it next day. if you find oil spot(s), clean the engine really well and repeat test, you should find where the oil is leaking from.

Posted on Sep 28, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
LT1Rob

Rob

  • 55 Answers

SOURCE: Torque Spec for '99 Chevy C1500 5.7L engine lower intake manifold

On 5.7L engines, install the bolts and torque in sequence as follows:

  1. Step 1: 71 inch lbs. (8 Nm).
  2. Step 2: 106 inch lbs. (12 Nm).
  3. Step 3: 11 ft. lbs. (15 Nm).
f2266b6.jpg

Posted on Mar 14, 2009

Anonymous

  • 366 Answers

SOURCE: 2001 Chvy van: overheat+water leak/from strange(new?) hole

seems u have a blown head gasket or cracked head!

Posted on Mar 18, 2009

STEVIE_N_24

steve golladay

  • 147 Answers

SOURCE: CHECK ENGINE LIGHT ON , WITH CODE SYSTEM TOO LEAN

Possible failed bank 1 sensor 1 oxygen sensor..

Posted on Mar 29, 2009

B_o_B_1

  • 270 Answers

SOURCE: 1997 Cevrolet Cavalier 2.4 liter engine leaks antifreeze

Nothing goes in that hole. If coolant is leaking from that hole, it means the shaft seal on the water pump is bad. The only fix is to change the water pump.

Posted on Jul 05, 2009

Carburetor1

Carburetor1

  • 32 Answers

SOURCE: 1999 chevy suburban 4x4 is leaking cooling from

replace the gasket but I would take it to a shop if you are not familiar with that engine the injection system will have to come out and it is delicate.

paul
www.carburetorexchange.com

Posted on Sep 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy transfercase I have 1995 2 door cab 2500 what years will work


gmc and chevy k1500 pickup and suburban years 95-99
k2500 pickup years 95-98
k2500 suburban 95-96
gmc k2500 and yukon 95-98
I hope that helps if so please rate my answer

Dec 26, 2014 | 1995 Chevrolet C2500

1 Answer

1995 chevy k1500 misfire and no start


The temperature sensor (the 2-wire one for the computer) are problematic on these trucks. Another problem area that commonly arises are the ground wires located on the thermostat housing bolt; they are often rotted out or broken, and this electrical connection is CRITICAL for proper engine operation. Make sure you address these two things before you shotgun any more parts at your truck. Hope this helps. Good Luck!!

Jan 05, 2014 | 1995 Chevrolet K1500

1 Answer

Chevy k1500 belt got strched


I was unable to find the bolt pattern on a 1995 Chevy k1500 5.7ltr. It might tell you in the owners manual.------------------------------------------------------------------------------------
Launch X-431 IV Auto Scanner

Mar 11, 2013 | 1995 GMC Suburban

1 Answer

1995 chevy k1500 5.7L 350 look for ways to make my engine run better and faster should i have it over hauled or place a new engine. either way i go i want to put a cold air intake and headers


how many miles are on it, if you biuld one it will cost alot with no warranty or you can buy a crate motor from gm with awarranty, i have put in a few crate motors and the run like crazy.

Dec 20, 2010 | 1995 Chevrolet K1500

2 Answers

Why is the back plate for my 1995 Chevy K1500 stepside cost $350.00? years before and after are around $30 bucks. What's up with this?


Because GM likes to change things for no reason at all. The 305 and 350 engines in the 80's and 90's have three different rear main seals. No reason at all, same transmissions and engines, even same engine codes, but different seals. They do this all the time and this is why, among other reasons, I don't buy or own GM or Chrysler vehicles.

Dec 05, 2010 | 1995 Chevrolet K1500

2 Answers

Does the 1995 Chevy Suburban have a solenoid and where is it located. thankyou


Yes it does, it is the small round canister bolted to the top of the starter. The starter is bolted to the bottom rear of the engine on the passenger side.

Dec 03, 2010 | 1995 Chevrolet Suburban

2 Answers

I have a 1995 Chevy Suburban K1500 with a 350 4x4, when I start it runs good. When I put it in gear and let idle it wants to die for the first couple or miles and then it's fine. I have changed the plugs,...


I would look at the timing belt if it's never been replaced. Sounds like it is having issues under a load or the tensioner isn't working properly. Another possible issue could be a vacum component that isn't functioning properly until the engine and transmission get wormed up.

Jul 27, 2010 | 1995 Chevrolet K1500

1 Answer

1995 chevrolet k1500 transfer case fluid fill hole


LOOK ON REAR COVER OF THE TRANSAXLE CASE.TOP PLUG IS FILL HOLE BOTTOM PLUG IS DRAIN PLUG.

Jun 19, 2010 | 1995 Chevrolet K1500

2 Answers

How do you remove the head restraints for front seats for 1995 2500 suburban?


At base of restraint plastic little cover will have small hole facing towards front, with a small pin stick in little hole and pull up on restraint work one then the other till it come's out.Hope this was helpful.

Dec 03, 2009 | 1995 Chevrolet Suburban

1 Answer

How do you check the oil level in the rear axle of a 1995 GMC K1500 Suburban? I can find no plug or inspection port.


there is a small plug on the passenger side of the diff near the top, you open it with a 3/8" ratchet. stick your pinky finger in, if you can touch fluid within a half inch of the hole the fluid is ok.

Nov 29, 2009 | 1995 Chevrolet Suburban

Not finding what you are looking for?
1995 Chevrolet K1500 Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...