Changing the rear disc brake rotor
SOURCE: How to change my rear brake light bulb
Okay you need to lift your trunk remove any carpeting remove hidden screws to undo light fixture be careful not to drop the case once case is in your hand remove the appropriate bulb that needs replacing after wards reinstall light housing/casing and screws good luck with this. Please Rate Me. And for further assistance you can always ask me.
SOURCE: 2006 toyota rav 4 fog light bulb replacement
fIRST YOU SEE A RUBBER GASKET SURROUNDING THE HEADLIGHT PLUG IN THE BACK OF THE HEADLIGHT ASSEMBLY. pULL OFF THE GASKET AND LET IT HANG ON THE SURROUN DING HEADLIGHT WIRES. tHEN PULL OFF THE HEADLIGHT WIRE HARNESS BY GRABBING THE SOCKET (NOT THE WIRES). AROUND THE BULB IS A THIN SILVER HOLDING SPRING THAT LOOSENS BY SQUEEZING THE ENDS TOGETHER AND ROTATING IT. iT WILL LOOSEN AROUND THE HEADLIGHT. WHEN THIS HAPPENS THE HEADLIGHT WILL "FLOP" AROUND AND PULL IT OUT, REMEMBERING TO SEE HOW THE THREE CONNECTORS ARE LOCATED (I.E - IS ONE CONNECTOR AT 12 O CLOCK POSITION AND THE OTHER TWO ARE AT 9 AND 3 OR ARE THEY AT 3,6 AND 9, ETC.). rE-ASSEMBLY IS THE OPPOSITIE. tHE TRICK IS TO GET THE THIN SPRING WIRE BACK IN PLACE. YOU HAVE TO SQUEEZE THE SPRING AND RE-POSITION IT SO IT KEEPS THE BULB SECURLY IN PLACE
Having just changed the bulb, I would advise taking the whole headlight assembly out first. It is near impossible to feel or imagine how to change the bulb without seeing it. First, use a phillips screwdriver to take the single screw holding the strip off just below the headlight assembly. By doing so, you will now see the other two bottom bolts holding the headlight in. Take all four bolts out then disconnect the bulb from behind. Then proceed as above.
SOURCE: On a 94 Toyota Rav 4. A warning light is on. It
its rear accel oil low light ,top up very soon as can do damage.there a nut on accel to drain and refil
SOURCE: 2008 rav-4 toyota brake pedal
If you own a Toyota with (BA) Brake Assist, it may be out of adjustment. It is adjustable on the 2010 Highlander and I would guess that it might be adjustable on your Toyota vehicle as well. (Assuming this is actually your problem, you have had it checked out by your service department and they said there is nothing wrong or that it was normal.) If the brake assist is out of adjustment it may be coming on too soon or when minimal brake pressure is applied. This causes a long brake pedal (brake fade or the pedal travels longer than normal before resistance is felt) and/or jerky brakes. As far as the Hill Climb Assist or DSC, this feature is activated when the brakes are applied after the vehicle has come to a stop and then you continue to press harder on the brakes for a couple more seconds. It also comes on if you drive with two feet. If you have your foot on the brake and you press slightly on the accelerator (when the vehicle is completely stopped), the DSC will come on and you will hear the chirp.
SOURCE: Where is the fuel filter on a RAv 4 2006 is
FUEL FILTER IS PART OF FUEL PUMP MODULE NOT SERVICEABLE.
322 views
Usually answered in minutes!
×