1998 rav 4 ecu pinout location

It is the Violet wire with Wht tracer (off of pin 9C) labeled SPD in the main ECM Engine Control Module.

Locate the E6 dark gray ECM 22 pin connector (two rows of 11 pins). The electornic signal you are looking for is on PIN9 be very careful.

Do Not use the ECM 26 pin or 16 pin connectors...just the 22 pin connector.

Sorry never done one so i havent a clue,in the good old days the tach connected to the coil wire but now with all this fancy electrics ,Well what happens is they call it vehicle security so they dont have to release the diagrams and this is done to stop people like myself from by passing the immobilisers when we service a vehicle.Because no doubt as you are aware on new cars that if you drop the oil the immobiliser cuts in.Change the battery and the same thing happens.So what happens to keep the dealers in work ,yes you have guessed it no wiring diagrams ,multilayered circuit boards and wires all the same colour to stop people like me from soldering the two outside legs together of a big switching transistor together to make the vehicle general mechanic friendly.Also encrypted software is used to stop the fault codes from being read ,they throw up the wrong code ?? try asking dealer to install then post where he connected too .,best of british with it

Just wanting to know where i can find the OBD11 diagnosis ON THE 1998, 4 DOOR RAV4 right hand drive, the exact spot if possible if anyone has any picture of the area to where i can find this