Turn signals not workong on 2001 Jeep Grand Cherokee. Checked fuses under hood and under driver side. Replaced flasher last year. They worked interemident until last week. Then both left and right have stopped.
Replace the turns signals flasher unit.
The problem is that the solder joints in the flasher break.
I had to take a few apart to prove this but here is the proof.
Two solutions...
No1Expensive, replace the flasher.
No2 Cheaper, remove and open the flasher without breaking it. Thin knives help. Soler the bad connections of the pins to the circuit board.
Photo included.
You can see the crack in the pin near the middle of the pic. To little solder and bad joint.
Just use real lead electronics solder. 63/37 lead tin. Hard to find but the Chinese will sell it to you on eBay shipped to USA. The lead free stuff is junk.
AE
1,991 views
Usually answered in minutes!
how do you replace turn signal on 2003 jeep grand cherokee LIMITED
how to replace turn signal lever on a 2003 jeep grand cherokee limited
whats ,eam kod 1684?
The jeep in this case does not run well and wants to stop.After replacing my plugs, it started flashing "check trans on the left and cruise set on the right.
no more details
Computer say p1495 readout on 2001 grand Cherokee
×