2001 caviler and it will turn over and want start

If the cranking rpms sound faster, check the timing chain/belt. Did you check for applicable trouble codes? Did you check fuel injector pulse? You used a gage and checked proper fuel pressure?

check the fuel pressure and make sure you got the correct pressure

If its the theft system. Check out this link. http://vatspasslockpasskeysecurityhelp.yolasite.com/

if it does not start while only turns, check if fuel comes out from pump ,also check ignition ,spark plugs good connection.

The plug gap is .040

Check the fuel/air sensor and air filter. When you first start the car only press the accelerator pedal once. If while turning the ignition switch you here a grinding noise that would be your starter going out. The smell of fuel signals that your car is either flooded from pressing pedal or fuel mixture is incorrect. Hope this helps.

Squirt starting fluid in intake and try to start if it starts and then dies you have a fuel delivery problem. Make sure you check the fuses for a blown fuse namely fuel pump or fuelpump relay. If it doesnt start after squirting starting fluid in the intake check for spark at the plug wires and coil.

Can you explain more so I can help. What do you mean still wont turn on, engines doesn't start or starter motor doesn't turn. Have u taken out a spark plug and connected it to the cable put the end of the spark plug to a ground and make someone turn on the engine for a few seconds you should see some blue sparks. Carefully use gloves. If no sparks, spark plug is bad next thing to check instead of putting the spark plug in the cable put Philips screwdirver put the screwdriver near a ground not touching about one inch make someone turn the engine for a couple of second you should see the spark jumping from the screwdriver to the ground, If there are no sparks ignition coil or spark plug cables are not good. But u say u changed ignition coil so maybe your cables are not good. There is a connector near the ignition coil disconnect it and turn ignition switch on measure the voltage you should have in between 12vdc + or - .5 vdc if no voltage present there is a blown fuse, Check for it

no the 96 is a bit more flat then the 2001 which has more curvature this [ versus this (

yes it could be the ignition switch.