Hi, my jeep grand cherokee's ignition key won't turn at all
SOURCE: Ignition Key Doesn't Turn Sometimes in 2001 Jeep Grand Cherokee
This is a tumbler problem. If you want to fix it yourself, you need to disassemble the the column untill you get to the lock cylinder and figure out how to remove it and remove the tumblers. This will allow many different keys to start the car however. Your other option is to replace the lock cylinder with a new one and new keys. That is up to you, but you should do something before the keys quit working all together.
SOURCE: Radiator fan will not turn off in my 2000 Jeep Grand Cherokee
usually the engine relay or cooling fan relay..!
SOURCE: How do you program a 2002 Jeep Grand Cherokee FOB?
if you have an original working fob and your owner's manual,it will explain procedure,otherwise will have to go to dealer to be programmed
SOURCE: 1994 Grand Cherokee Jeep wont start
It is likely one of your battery cables loose. Same thing just happened to me today. What you need to do is first lock the doors, and close them. Then you need to disconnect, and reconnect the battery cable, then if the security lights still blink you must use your key to unlock the door, then it should stop blinking, and start just fine.
SOURCE: describe your ignition key trick for checking code
turn the key on/off on/off then on and wait.
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
530 views
Usually answered in minutes!
×