SOURCE: 1996 jeep cherokee sport starter
disconnect the battery, negative side first.
remove both positive wires from the starter.
remove the bolts from the starter.
install new starter.
make sure positive starter wires are free of corrosion and rust, use sand paper or a file.
tighten positive wires just snug, then another 1/4 turn, ** not too tight or you will snap the stud off the starter solenoid**.
coat wire ends and starter studs with die-electric grease, battery protector, spray paint , or something non metalic.
connect vehice battery, negative side last.
SOURCE: 1996 jeep cherokee sport where do i add freon
Look for the a/c pipe that has a blue cap on it, that's the low pressure side where the freon goes.
The pipe with the red cap is the high pressure side, you don't put the freon in that one.
I can't tell you exactly where the connection is, different models are in different places.
SOURCE: My 1996 Jeep Cherokee Sport dies or will not start when hot.
Sounds like the ignition coil is getting bad.
SOURCE: Where is the location of the fuel pump reset
You don't have one on there. Pump is turned on and off by the automatic shutdown relay and the pump relay. The crank sensor signal keeps it on. If the asd relay does not get a signal from the computer (from the crank sensor), it turns off the pump relay (and spark).
The pump should run when you first turn the key on. When you start the engine, if the computer gets no signal from the crank sensor it will shut the engine off (no fuel, no spark = off)
If when you first turn the key to on, you can't hear the pump, likely either the pump has failed (check power at the pump harness) or the relay is bad.(swap relay for a known good one and try it).
SOURCE: lookong for sepertine belt diagram for 1996 jeep
Check this diagram...
Also, I suggest check in this link, How to change a serpentine belt on a 1996 Cherokee in 70 steps.
Hope helps (remember to rate this ansewr).
114 views
Usually answered in minutes!
×