SOURCE: rough idle stalls at low rpm's
hello first check your idle with the car running foot on brake see were your rpm reading is if your below 500rpm check your label underhood for your curb idle setting second see if theres a adjustment screw you can increase were your gas cable lever rest against your set screw underhood if you feel confident enough remove your iac motor idle air control valve if the bore were the end of the pintle extracts out to close has varnish builup our carbon it will stick creating vacuum leak type senario causing stalling rough idle sometimes even no start conditions good luck
SOURCE: The idle drops when i put it in gear almost stalling the engine
That is normal, in park or neutral there is no resistance on the engine when you put it in gear there is resistance because the car wants to move. Also when you turn on the ac that turns on the compressor that is run off the belts of the engine so it puts more resistance on the engine. Low idle is not a problem unless the engine dies.
SOURCE: starts fine,idles fine,stalls when put in gear to
Try depressing slightly the gas pedal to see if the engine continues to run when you put it in gear. Might have to depredd gas pedal and brake simultaniusly. if the engine continues to run, then the problem is in the idle circuit. Try decarboning the throttle body and the idle speed control.
SOURCE: rough idle in gear (drive). Sometimes it stalls
Sounds like the EGR valve needs to be cleaned or changed.Hope this helps.
257 views
Usually answered in minutes!
×