CAR CUTS OFF WHEN PUT IN GEAR

Your transmission needs to be repaired. This is going to be at a starting point of 1700.00 and cap off at about 2300.00.

Dirty fuel filter,too low,low idle,dirty throttle body.

Could be a faulty torque converter but that would not explain having to use a jumper. Have you let the engine run for 5 or 10 min before shifting into gear ?

On some of the newer card when your low on oil or transmission fluid the car will not move. Check your fluids and then try again. It worked fofor me, a mechanic told me this and I thought he was crazy but it worked

slave cylender

so it idles fine as long as it is in park. when you shift it into gear it stalls?

Does it feel like if you had a manual transmission and you let out the clutch with your foot on the brake?

if you are in a place you can do this safely without hitting anything try starting it while the transmission is in neutral. After it starts put it into either drive or reverse with your foot off the brake. Does it start to move, then the rpms start to drop fast and then stall?

Again if you can do this in a safe place what happens if you do the above and as soon as it goes into gear you give it a little gas? Will it move and stay running until you come to a stop? If yes the torque converter is locked.

Unfortunately from the description of the fluid and this symptom your likely looking at replacing the transmission.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

It sounds like you have a torque convertor issue. But you will need to take it to a shop to be 100% certain.

i am arko iam looking for a softare for haking for mobile phone line & and memory

Have you tried cycling key for fault codes? Turn ignition to on (not start) then off, then on, then off, then on, leave it on, and count flashes of check engine light.
flash,flash,pause, flash flash, is code 22. 3 flashes, pause, then 5 flashes, would be code 35, etc. See what you get, & get back to us with them if you need more help.

i hate to say it you might have got a faulty starter i mean the bendix where the motor and gear touch the flywheel