Grinding sometimes while shifting

SOURCE: 1991 jeep wrangler sahara shifting promblems

Your clutch is not disengaging. If it a hydrolic clutch chk. the fluid in resavor, Or slave cyl. for the clutch is bad, Or it has got air in it and needs to be bleed. This is a clutch problem, nothing wrong with trans. If its a manual clutch linkage its an ajustment thing. My best guess if its hydrolic slave cyl. went bad, or resavor is out of fluid.

SOURCE: 1984 Jeep CJ7, Gear shifting / Linkage problem

likely the shift rails are worn inside the trans. In changing shift, you have removed the wear on the end of the stick, but not the corresponding wear where the stick fits into. It will need to be taken apart to repair this. (would not hurt to have synchros replaced at the same time.) OR, replace transmission if you have an inexpensive one available.

SOURCE: HELLO EXPERTS I have a 1995 jeep wrangler with

Check all your hydraulic connections for seepage . If you find nothing leaking, check where the rod goes into the master cylinder under the dashboard...If still nothing, I'd change the master cyl, as it is likely internally bypassing and permitting the clutch to release. PS it takesa a special "touch" to shift gears without using the clutch, if you cannot do that don't drive it Till you get it fixed...you will damage synchros and will need to have trans removed and rebuilt. $$$you don't want to spend!!!

SOURCE: 2000 Jeep Cherokee Gear Grinding & 4WD Whine sound

Give a try by change your transmission/filters and Transfer case oil.

SOURCE: 1989 jeep wrangler wont shift gear and clutch gone loose

Get the clutch slave cylinder and master cylinder looked at.One of the 2 has failed.If the pedal goes to the floor or is very loose,this is very likely the cause.Not an expensive fix.Hope this helps

Testimonial: "succinct. precise. prompt. thank you so much."