Surpentine belt broke then the motor would not start after the belt was replaced
SOURCE: surpentine belt.
depends on which v8 you have....the 4.7 the routing is as follows it goes under the waterpump pully over the alternator down and around the power steering pumpto the crank...it goes under the bottom of the crank to the idler pully.the flat side of the belt goes ver the idler then around the automatic tensioner to the ac compressor.
on the 5.2 and 5.9 it routes starting at the idler pully the flat side goes undr the idler the up to the ac compressor around the compressor and down to the power steering pump ... around power stering pump to waterpump where the flat side is against waterpump pully around water pump down and around crank up it automatic tensioner....around tensioner and up and over alternator
SOURCE: need to replace the surpentine belt
depend what engine you have for the 2.2L engine you need a 3/8 ratchett or use the belt removal tool fit it in the square slot on tensioner rotate counterclockwise. the 3.0 engine you have to use a box end wrench rotate to right.
SOURCE: surpentine belt routing diagram for 1999 vw beetle
start at crank goes around crank pulley and ac compressor then inside the idler back out around alternator theninside tensioner belt will almost touch itself between pulleys
SOURCE: how to replace surpentine belt
Unless you have a little experience working on cars this could be tough. There should be a picture of the belt routing somewhere under the hood. The tricky part is the tensioner, it has to be pulled up to get the old belt off and the new one on. It should have a square hole in it, I use a 3/8 drive long handled breaker bar to fit in the hole and pull up on the tensioner.Have patients and good luck.
SOURCE: how to replace the surpentine & drive belt for Town ace - Toyota
you are going to need i believe a 15 or 17 mill box-end werench. Find the tensioner pully. it looks like two small pulleys attatched by an aluminum bar. put the wrench on the pully that dosnt move that looks like it is bolted to the engine and pull one way ot the other and it will loosen the belt. Under your hood there should be a white sticker with a diagram on how to put the new accessor/ serpenitne belt on. If you are having troubles before you try this go to your local autozone or checker auto parts and have them show you. Usually they are nice enough to help out.
123 views
Usually answered in minutes!
×