1998 jeep grand cherokee sometimes when you tried to start the vehicle it wouldn't start on first try .... but when you turnned off the key and hit it again it would start .... after sitting 5 days now it want start at all . I just installed a new fuel pump and it didn't help ? what next
SOURCE: 1998 and 2000 jeep grand cherokee
This Info taken from Wikipedia, the free encyclopedia
http://en.wikipedia.org/wiki/Grand_Cherokee
Hopefully this will answer your question.
The redesigned WJ 1999 Grand Cherokee shared just 127 parts with its predecessor. The structure was stiffened by PorscheEngineering for sharper steering and lighter weight. The spare tire wasrelocated from the side of the cargo compartment to under the floor togreat relief of owners. The two heavy pushrod V8 engines were replaced by chrysler's first clean sheet V8 since the 60's (SOHC aluminium heads, plastic intake), Chrysler's then-new PowerTech. Although this engine produced less torquethan both previous V8s, it was lighter and got much better fuel economyand provided similar on road performance figures (the 23 gallon fueltank was replaced with one of a 20.5 gallon capacity). The Inline 6engine was also updated in 1999. 10 horsepower (7.5 kW) was added byredesigning the intake manifold. The manual transmission was dropped with this model.
While other Jeep vehicles used the Mopar 5 x 4.5 bolt circle, thiswas the first Jeep following the 1987 Chrysler buyout to receive awider bolt pattern — 5 x 5. The 5 x 5 bolt pattern (also 5 x 127 mm),although common to GM rear wheel drive vehicles and light dutytrucks/vans, has spread beyond its use with GM (and Ford with their 1973 to 1978 LTDs and Lincolns). Chrysler first used the 5 x 5 pattern on full-size half-ton Dodge Ram pickups and Dodge Ramcharger SUVs in 1986.
A notable feature available in this generation was the automatic four wheel drive option called Quadra-Drive II.With three viscous clutches, it was one of only a few four wheel drivesystems at the time with triple locking differentals, joining thecontemporary Mercedes Gelandewagen, Mercedes Unimog and Magna SteyrPinzgauer, and the only one of the four with fully automatic operation,although the axle differentials could not be manually locked like inthe other three vehicles.
The 45RFE and 545RFE automatic transmission in the WJ was notable. It included three planetary gearsets rather than the two normally used in a four-speed automatic. Thisgave it six theoretical speeds, and it would have been the firstsix-speed transmission ever produced in volume, but it was programmedto only use five of these ratios. Four were used for upshifts, with adifferent second gear for downshifts. Although five of the six ratioswere used, Chrysler decided to call it a "4-speed automatic". In 2001,the programming was changed to make use of all six ratios. Rather thanhave six forward gears, the transmission was programmed to act as afive-speed with the alternate second gear for downshifts. The RPM at70 miles per hour (110 km/h) on a 545RFE is 2000 rpm, 200 rpm less thanthe 45RFE programming. 1999 and 2000 model year WJ owners can havetheir 45RFE transmission's programming flashed to enable the extra gearas both transmissions are physically the same. The 42RE 4-speedautomatic remained the transmission for the Inline 6 engine. It was notchanged from the previous model Grand Cherokee's.
SOURCE: 2005 Jeep Grand Cherokee Shifting Problems
Check the Trans fluid level with it running and at operating temperature. Jeep NAG1 transmissions are known to have the input electric seal leak trans fluid. Not an exspensive fix add Mopar ATF4 and then relace the guild seal.
SOURCE: where to replace coolant temp sensor for 1998 grand jeep cherokee
Check this image...
...in the Section ZJ-Secc-8D-Ignition-Systems (page 5, fig. 10 and 11).
Good luck.
SOURCE: 1998 Jeep Grand Cherokee Laredo 4.oL I got a code po113
Trouble Code: P0113 (4.0L L6 VIN S Auto)
IAT Sensor Circuit High Input
Print this code data
Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
Check with ignition on or engine running; battery voltage more than 10v; The PCM detected the IAT Sensor input was over 4.90v (exc. Dakota, Durango, Ram) or 4.98v (Dakota, Durango, Ram) for 3 seconds.
Possible Causes:
SOURCE: change a headlight assembly Jeep Grand Cherokee
Just need take off the screws; for details check the graphics and ilustrations in the Jeep ZJ Grand Cherokee Service Manual
Hope helps (remember rated this) Good luck..
206 views
Usually answered in minutes!
i have a 1995 jeep grand cherokee and it has a mind of its own it will stall out while im driving and sometimes it will start sometimes it wont i have had two mechanics look at it and cant figure it out please help!!
Is there fuel pressure at the rail? do you have spark at the coil, at the plugs? what have you checked and why did you change pump? did you check fuel filter & relay?
Do you have fuel? do you have spark? what have you checked and why did you change pump? did you check filter and pump relay?
Is it a new or reman fuel pump?
×