P1756 diagnostic code

Contrary to popular belief (and sometimes the salesperson's claims), AutoZone is not a repair shop. They can read the codes and tell you what the code means, but buying parts doesn't always fix the problem. You can check the link provided, or you can take your Ram to a professional shop, where they (normally) warrant their work.
have code p1756 on my dodge ram 1500 44 What could be the problem how much...

get your jeep to a transmission shop either the pump is going out or the governor pressure valve is bad so the solenoid pack may need to be replaced.

Hello,

Trouble code P1756 means: Governor pressure not equal to target at 15-20 ps
Governor pressure in the trans is not correct. Fairly easy fix. Drop the trans pan and get a governor pressure solenoid from your local dealer. Bolts in pretty easy.

I hope this helps. Mike from fixya

P1756 (M) GOV Press Not Equal to Target @
15-20 PSI
a tranny shop will have to fix this, it is in tranny on bottom. Suspect faulty solenoid.

P1756 = Mid presure malfunction, governor, sensor, etc.. When the governor sensor malfunctions it can cause damage to the clutches. Change out the governor & solonoid. Below is a link for a good video regarding repair of this problem.
http://www.youtube.com/watch?v=TWXaoC3Qi...

I also work for autozone, 5+ years, and these are not trouble codes. I would find another Autozone and have them re-read it. Trouble codes would look like this: P0300, or P1756. The codes you have are not correct. Also, they should take you inside, look up the code, and explain what they mean. Also. ask them to print them out.

P1756 what does this mean: It is transmission related, difinition is: transmission governor pressure not equal to target...its a transmission code this is a common failure... have seen these governer pressure sensors fail often.... most codes are governer pressure sensor volts too high or low, governer pressure sensor not equal to target.. Most of the time you replace the governer pressure sensor and soleniod.. I would recommend you to fix this problem if not you will end up burning the clutches in the trans... The trans pan needs to be removed....the sensor is bolted to the valve body and is located on the pass front side of the valve body.

Governor pressure in the trans is not correct. Fairly easy fix. Drop the trans pan and get a governor pressure solenoid from your local dealer. Bolts in pretty easy.

Hi I'm litoshop code p1756 is gov press not equal to target @ 15 to 20 psi this is a transmission code good luck if this information has been useful please let us know thank you

Could be a bad sensor, but it's transmission related. Anything affecting internal trans pressures should be taken care of by a reputable trans shop.