How to remove the door panel on a 96 Ford Thunderbird?

SOURCE: remove door panel on a 1994 ford thunderbird

Here is the removal procedure in detail

SOURCE: how do I remove the inner door panel on a 96 ford crown vic without damage?

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

SOURCE: 2003 ford thunderbird how do you remove inner door panel?

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

SOURCE: ReMoving door panel to replace

please rate highly if this helps.

Front Door Trim Panel Printable View (126 KB)

1. Disconnect the battery. For additional information, refer to Section 414-00.

1. Remove the components in the order indicated in the following illustration and table.
   
   
   Item Part Number Description 1 23712 Sail panel 2 221A18 Door handle cup cover 3 W706476-S424 Screw 4 237A98 Door handle cup assembly
   Removal Note 5 18978 Speaker cover 6 - Speaker electrical connector (Part of 18808) 7 W706476-S424 Screws (7 req'd) 8 23942 Door trim panel
   Removal Note

1. To install, reverse the removal procedure.

1. Lift up at the front of the door handle cup assembly, move it forward to remove and disconnect the electrical connectors.

1. If equipped, disconnect the electrical connector.