It happened last week then again this week it stalls and the battery light stats blinking the rpm meter goes to the max you can get it to go at little bursts by puttin the pedal to the floor last week it was running perfect after an hour then this week it wasnt till the next day it dont bring up any codes i replaced the pcv valve all vacum lines are hooked up
SOURCE: brake pedal goes to floor
there is still air in your hydraulic lines somewhere bleed the system with a pressurised power bleeder and you will get instant results
SOURCE: brake pedal dropping to floor
do u have the antilock brake bleeding tool? if not you will need to have the dealer bleed the brakes, the ABS control valve must be electricaly held open to bleed the brakes there of course is a special tool for this.
Testimonial: "Thank You"
SOURCE: starts/stalls won't run until pedal tapped, 2
Check your IAC motor (Idle Air Control) It could be sticking open.
Ps. Might be called Idle Speed Control motor it depends on the make and i forget what chevy calls theres.
113 views
Usually answered in minutes!
×