2000 audi a6 location of iat sensor wires on intergrated maf

Check your wiring; you may have lost a ground connection common to all those sensors.

Intake Air Temperature (IAT) sensor and Manifold Absolute Pressure (MAP) sensor are combined into a single assembly which is called Mass Air Flow (MAF) sensor. This MAF sensor is located on the air filter box near air filter hose, and is connected with a five wire connector. You cannot replace the IAT sensor alone. Instead a MAF sensor is replaced altogether.






Thank you for visiting Fixya.

The neon does not have a MAF sensor. The intake air temp sensor is located in the air snorkel between the throttle body and the air filter.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

ATTEMPTING TO LOCATE THE TWO IAT WIRES IN THE MAF SENSOR PLUG TO INSTALL PREFORMANCE CHIP IN a 2012 COLORADO 3.7 engine.

This vehicle has MAF or IAC sensors - not ?? MAF or IAT ??

Which do you need the wiring for?

in the inlet air pipe from the air filter to the manifold

the IAT sensor is part of the Mass Airflow sensor. here is a picture of that sensor.

P0102 - Mass Air Flow (MAF) Circuit Low Input
The MAF sensor circuit is monitored by the PCM for low air flow (or voltage) input through the comprehensive component monitor (CCM). If during key ON engine running the air flow (or voltage) changes below a minimum calibrated limit, the test fails. MAF sensor disconnected
MAF circuit open to PCM
VPWR open to MAF sensor
PWR GND open to MAF sensor
MAF RTN circuit open to PCM
MAF circuit shorted to GND
Intake air leak (near MAF sensor)
A closed throttle indication [throttle position (TP) sensor system]
Damaged MAF sensor
Damaged PCM
A MAF V PID (MAF PID) reading less than 0.23 volts (Refer to equivalent grams/second chart in GO to Pinpoint Test DC ) in continuous memory or key ON and engine running indicates a hard fault.
P0113 - Intake Air Temperature (IAT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The IAT sensor maximum is 4.6 volts or -50°C (-58°F). Open circuit in harness
Sensor signal short to power
Damaged sensor
Improper harness connection
Damaged PCM
IAT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

the iat is part of the maf sensor located in the air filter duct or housing. 6 pin connector. pin one color violet/gray is for iat. pin 2 is c-signal rtn yellow/violet. pin 3 maf yellow/violet. pin 4 maf rtn blue. pin 5 ground black/yellow pin 6 circuit breaker fuse 76 blue/brown

iat screws into intake mine has two wires different year though.