Question about Cars & Trucks

1 Answer

2003 xtype will not turn on,switch problem it looks like ,i removed etc to clean and now its hard to get the switch to even wants to start whats my problem someone please

I removed the etc box to clean now it wont start,also did engine dun-up

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 20 Answers

Has the battery been disconnected? If so, I have heard of this problem. The on board computer speaks to the car constantly and after 10 days of non charging the battery is flat! The only solution is a visit to your nearest Jag garage to get it all re-programmed, this solution would also include Battery disconnection. Check with a Jag garage first, it's free to ask, but this sounds like your problem. A major design flaw if you ask me.

Posted on Feb 24, 2013

Ad

1 Suggested Answer

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont it start after changing fuses


posible you remove a fuse that the car need ck the fuse box on engine comparment

Oct 20, 2014 | 2002 Buick Rendezvous

1 Answer

I have a 2006 camry v6 engine having proplem with engine starting and when engint starts rpm goes up and down with fuel mixture rich


HI !
YOUR CAR ENGINE IS ETC SYSTEM ? (electronic throttle control) i think need clean the throttle body first .disconnect the ETC fuse & EFI fuse in fuse box more 1min .after connect back the fuse .turn switch on 1min.off all electrical A/C or lighting .star the engine hole the throttle 2500-3000rpm 3 min .last turn off engine & start the engine .this is ETC learning .

Oct 17, 2014 | 2006 Toyota Camry

3 Answers

Why wont car start


First put the battery on to a proper battery charger over night. If it clicks after that, the solenoid or starter is faulty.

Jan 21, 2018 | 2004 Chrysler Sebring Convertible

1 Answer

Wont start after it gets warm


This is an interesting fault. The click you hear is the relay, that puts power on the starter motor, but you do not hear the starter motor turn. (Or do you?)
First suspect is the battery, they do get old and tired, but you say after a while it cools down and starts, so its probably not the battery. Check the cables to and from the starter motor, and the fat earth cable from the engine to the body (in the engine bay) make sure they are undamaged, clean and the connections are not loose. IF all looks ok I suspect the starter motor. remove the starter motor and clean it.

Dec 19, 2013 | Hyundai Motor 2004 Accent

2 Answers

2004 alero turn key car clicks but wont start


Dead battery. Try jump starting it. Then stop by any good parts store (Advance, Autozone, etc) and have them to a FREE charging system test and a FREE battery load test. I suspect your battery has left this planet...

Feb 27, 2011 | 2004 Oldsmobile Alero

1 Answer

Help my mercedse says display faulty visit workshop. it wont start. i just had a full sevice performed and was told it can drive far distances. the lights, radio etc work just zero response from engine


Have you checked your fuses? Check your owners manual for location of your fuse boxes. Normally under rear seat and under hood in mercedes. Check the reference card in the fuse box for any fuses corresponding to the engine,I.E. engine, Fuel pump,etc. Check those fuses to see if any are blown. If the fuses are all good then it is probably the ecm (electronic control module).

Feb 03, 2011 | 2003 Mercedes-Benz E-Class

1 Answer

2001 ford focus: only 1 headlight works on low beam, already replaced socket,also engine wont crank, new battery all fuses are good. also fuel pump not working! My brother was playing around in the fuse...


start by getting the car to run...If you played with the fuses and battery, this is where to start. Clean the battery terminals and tighten them after cleaning...test the fuses-the tester is about ten bucks at most autoparts stores...If after that no start, then you will need to break out a multimeter and find the short circuit.

Mar 14, 2010 | 2001 Ford Focus

1 Answer

WILL NOT START


sounds like water ingress to either a control module or the coil pack, check all control box locations eg footwells for water and then check the engine bay for loose or naked wires, dry and clean and possibly cover with a plastic bag etc and it should be fine.

Jun 14, 2009 | 2000 GMC Safari

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...