We are replacing the Airbags and the Module in this car, but can't find the Module.... Can anybody help?!?!?!
SOURCE: Needing to locate the airbag control module '07 caliber
it is located behind the floor shifter in center console..under small piece of carpet
SOURCE: 2000 Chevrolet Malibu LS airbag problems
The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.
SOURCE: Airbags deployed
You have to disconnect the battery, replace the air bag modules (air bag modules are the things that explode in your face) and the crash sensors and the control unit or module that came with it. Reconnect the battery and the car should start. Hope this is helpful.
SOURCE: location of body control module on 2007 saturn ion
Bcm and fuse box are one piece, located in front of center console, just under the heater controls. Remove side panels from console on both sides.
1,047 views
Usually answered in minutes!
×