OBD2 code P2096 on a 2007 Jeep Liberty
SOURCE: sloppy shifting on 2007 jeep liberty
i think you go to dealer to reprogram the transm. by original programmer
SOURCE: all my windows are falling down in my 2007 jeep
if they are manual wind ups you will find that the regulator mechanism has worn or worked loose and its not holding up the window,need to remove door trim to assess the issue
SOURCE: jeep liberty 2007, window regulator died. What is
take off door panel and tap with a small hammer
SOURCE: 2005 jeep grand cherokee trouble code p2096 change
These conditions MUST be ruled out entirely.
Check for any of the following conditions/mechanical problems.
AIR INDUCTION SYSTEM - must be free from leaks
ENGINE VACUUM - must be at least 13 inches in neutral
ENGINE VALVE TIMING - must be within specifications
ENGINE COMPRESSION - must be within specifications
ENGINE EXHAUST SYSTEM - must be free of any restrictions or leaks
ENGINE PCV SYSTEM - must flow freely
TORQUE CONVERTER STALL SPEED - must be within specifications
POWER BRAKE BOOSTER - no internal vacuum leaks
FUEL - must be free of contamination
FUEL INJECTOR - plugged or restricted injector; control wire not connected to correct injector.
Unfortunatly, a scan tool will be required to monitor o2 sensor voltages while the engine is running in closed loop. This code you are displaying is NOT an easy solution to trace down. I expect you had an exhaust leak and is why the cats were replaced? Anyway, if so, the PCM can reset the light after a few GOOD trip readings occur that will satisfy the PCM's no fault signal, otherwise the JEEP dealer is going to be your only solution and a pressure test should be performed.
SOURCE: Fuse for brake light on 2007 Jeep Liberty
I dont have owners manuel and need to know what fuse is my brake lights ? All brakes lights are out . Thank you
79 views
Usually answered in minutes!
×