1995 Geo Prizm Logo

Related Topics:

al domeier Posted on Feb 19, 2013

95 geo prizm soft brake peadal - 1995 Geo Prizm

1 Answer

Cookie

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

  • Contributor 17 Answers
  • Posted on Mar 22, 2013
Cookie
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Joined: Mar 22, 2013
Answers
17
Questions
1
Helped
7587
Points
36

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jul 30, 2008

SOURCE: 95 geo prizm hamonic balancer belt pulley

Wow!!! I don't think I would put that much faith in gorilla glue. I had the same problem and had to replace the hb pully. My belt ended up slipping and jumped a few teeth causing the car to be badly out of time. Fix it before that happens.

Ad

Anonymous

  • 125 Answers
  • Posted on Sep 22, 2008

SOURCE: 1996 geo prizm

you'll have to pull off the interior panel. window in the up position. on the lock cylinder there is a clip that you have to pull off and an arm that actuates the lock. pop the lock out. reverse to install.

Anonymous

  • 142 Answers
  • Posted on Feb 12, 2009

SOURCE: 1994 GEO Prizm Fuel Guage

You need to replace your fuel sending unit. It is located inside of the gas tank.
Please remember to rate this solution.

Anonymous

  • 1 Answer
  • Posted on Apr 13, 2009

SOURCE: Geo Prizm brake lights

I had the same problem, what I did to fix it was as follows:

  • Removed the plastic light holders from the tail lamp.
  • On each of the three bulbs there is a ground wire that is attached to the plastic light holder via a screw. Remove these connections and clean, I used some very light sand paper.
  • Reassemble, Worked like a Charm for me, and I save a $90 charge from Firestone by doing it myself...

Molson02536

Harvey N Tawatao

  • 3854 Answers
  • Posted on Dec 23, 2009

SOURCE: geo prizm stereo radio wiring diagram

1994 Geo Car Stereo Wiring Schematic
Car Radio Battery Constant 12v+ Wire: White
Car Radio Accessory Switched 12v+ Wire: White/Black
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Red/Yellow
Car Stereo Dimmer Wire: Red/Green
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): White
Left Front Speaker Negative Wire (-): Black/Blue
Right Front Speaker Positive Wire (+): Blue
Right Front Speaker Negative Wire (-): White/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Light Green
Left Rear Speaker Negative Wire (-): Light Green/Black
Right Rear Speaker Positive Wire (+): Gray
Right Rear Speaker Negative Wire (-): Gray/Black

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Tail lights stay on while car is off and brake lights do not work,turning signals do work also, it is a 95 geo prizm

Try to refer to the owners manual. If not, go to the fuse box and see if anything is wired wrong. If you don't know, go to the car dealership and they will test the car and give you a report.
0helpful
1answer

Soft brake pedal

bleed the brakes again . start with the rear right wheel then rear left then right front . do it several times and ensure there is no air in the system
0helpful
1answer

How do i remove a 95 geo prizm dashboard

there are special fasteners all around the dash but you can either contact autozone for a printout or a body shop that oyu know of..
1helpful
2answers

I have a 96 geo prizm. I have replaced the front and back brakes. I have bled the brakes and the foot pedal is firm for about the first4 days. After the 4 days the brake pedal gets really soft and you...

It sounds like master cyl. is drawing in air causing prob. also another test would bee too bleed out and get pedal back, now step on pedal and hold firmly and see if pedal creeps near floor indicating innternal leaking in master cyl. also have some one pump bakes slowly aand look for air bubbles in brake res. after bleed out indicating master cyl. is drawing air upon release of pedal.
0helpful
1answer

What type of brake light bulb do I need for a 95 geo prizm?

Take the old bulb out, there will be a number on the bulb, you can take that number or whole bulb to any parts store to have it replaced. '
If there is no bulb, again a parts store can look up the vehicle and get the correct bulb replacement
0helpful
1answer

Where is the fuel filter on my 95 geo prizm?

It is bolted to the firewall under the brake master cylinder. It has a banjo bolt on the top side and a double flare on the bottom.
0helpful
2answers

Turn signal lights and hazard on my 95 geo prizm don't work

look for ur fuse box the fuses are in therehave manual info should tell you where fuse is
1helpful
1answer

1993 Geo Prizm Lsi Harmonic Balancer

Yes a harmanic balancer from tha corolla is the same thing. I had to do the same thing with my 95 geo. It works out to be a lot cheaper buying for a toyota than a geo.
0helpful
1answer

95 geo Flashers

It's probably a blinker relay. If you can find one, it'll probably be remanufactured or from a junkyard. Take it to the mechanic.
0helpful
2answers
Not finding what you are looking for?

87 views

Ask a Question

Usually answered in minutes!

Top Geo Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...