SOURCE: 2007 gmc sierra 2500 IAT sensor
Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.
SOURCE: 2003 GMC Sierra Knock sensor and oil pressure??
the knock sensors are located below the intake plenum,or,upper intake manifold as some call it, they screw into the lower intake, the front one is sensor 1, the rear is sensor 2. it is wise to change both if you have some miles.since you are going to be buying a gasket set to do this job.the sensors are cheaper than the gaskets.
SOURCE: Where is the oil pressure sensor located on a 2003
It is on the top backside of the engine block, behind the intake manifold mounted into the top of the block. You will have to lean up over the engine to see it.
Testimonial: "Thanks for the help"
SOURCE: where do i find a knock sensor a 1993 gmc sierra
Should be on the right side of the engine by the starter.Has a 1 wire connector.It does not go into the cooling system so you can just take it out without draining the coolant.Hope this helps.Good luck.
SOURCE: I need the firing order of 1996 gmc engine sierra
For the 1996 GMC SIERRA with 5.7L V8:
Firing Order:
1-8-4-3-6-5-7-2
Cylinders:
.........(back).........
|...8...|........|...7...|
|...6...|........|...5...|
|...4...|........|...3...|
|...2...|........|...1...|
.........(front)
Distributor Connections:
............(back)
Coil--->o
6------->o........o<-------5
4------->o........o<-------3
2------->o........o<-------7
8------->o........o<-------1
.............(front)
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
117 views
Usually answered in minutes!
×