Got car back from bodyshop and my doors are locking automatically - had to call service 2x bc car was locked while running. As soon as I unlock the car --- It seems to lock 5 seconds later - I get in close the door and the thing locks. Autobody shop says all is in working order and dealership says I have a setting wrong - but both as we know are wrong - any ideas ?
SOURCE: 2001 Hyundai Elantra door locking problem
there is a short or a signal from the un-locking switch that is triggering your locks.
you have a switch manually to lock and un-lock your doors, the unlocking circuit is making contact.
you can try playing with your switch to un-short the switch or open it up ang check it.
tnx 4 using fixya,
drcool
SOURCE: Door locks don't work
Disassemble the paneling on left side ,under the steering wheel. Remove all screws and pull out the panel until you can you can reach behind it to remove the two Black Relays, on the side closest to Steering wheel. Remove the Relay covers, Clean the contacts with a 1/8 fine strip of 600 wet/dry sand paper. Only place the paper between the contacts, and pull out while holding slight pressure on the relay Armature. Turn over the sandpaper and repeat once again. Very gently press the TOP resting contact pad closer to the armature, to lessen the gap between the contact points, so the armature doesn't have to travel as far to reach the closed contact position. Repeat the above with the other2nd Relay. Replace the covers, reinstall the relays And test the Door locks prior to buttoning up the paneling. Note, a pair of long needle nosed pliers will help in removing the relays. Just Grip the relay and rock in Forward and Backward as you apply upward pressure.
SOURCE: doors lock automatically
if they are locking when first start driving this is normal in the sonota and can be turned off at your dealer at no cost
SOURCE: Power door locks wont work
take off door panel so you can see the power door lock actuator moving there maybe rust or a bind in the power door lock little motor itself
SOURCE: Acura tl 2008 CODE ERRORE
radio is locked out from installing incorrect code to many times need to disconnect battery for couple minutes then reconnect and install correct code
164 views
Usually answered in minutes!
×