Need wiring diagram for older chev steering column,connecter was

The brake switch at the pedal does have six wires, but none go to the multifunction switch (on the steering column). The white wire with tan tracer goes to the combination flasher to be integrated with the turn signals/hazard lights. The combination flasher is under the dash next to the steering column and has a sixteen pin connector (ten of which have wires).

hope it helps I suspect that you have a starting problem usually there is 2 little wires Inside column steering connect to cyllinder key are cut
you can test it at the end of steering column 2 very little yellow wire ...put key in ignition cylinder and with ohm meter take resistor value if none wire is open circuit.

On Cadillac Deville, the Flasher is located:
- Hazard flasher: Front seating area, driver side, under dash, mounted on passenger side of steering column
- Turn signal: Front seating area, driver side, under dash, mounted on passenger side of steering column

1. Remove the necessary sound insulator panel(s) from under the instrument panel.
   
2. Remove the flasher from the retaining clip and disconnect the wiring connector.

To install:

1. Connect the wiring connector to the new flasher and install the flasher in the retaining clip.
   
2. Install the sound insulator panel(s).

If you need additional details, diagrams or some copy about Owners Manual, click it to contact us.

Hope this helps, dont fogetted to rating this answer and leave us a testimonial comment.

Hi, replace the flasher. It's below the instrument panel, left of the steering column. Looks like the picture below.

in the steering column behind the steering wheel under the turn sig lever there will be two contacts for left and right, check to make sure theyre being touched by the lever and if they are check the wiring on them down the line to make sure their is no melted wires/shorts hope i helped =)

The turn signal flasher and hazard units are usually located located under the dash either to the left or right of the steering column on most models:

1. Remove the turn signal flasher unit or hazard unit by pulling them up from the electrical connection.
2. To install, push the unit(s) into the electrical connector.

Also, I suggest check your repair manual in this link: Jeep ZJ-Secc-8W-Wiring-Diagrams

Hope helps (remember rated this).

H).l-blu wire connect to left front turn signal J).dk-blu wire connect to right front turn signals K).brown wire connect to hazard/flasher relay output L).purple wire conect to turn/flasher signal M). yellow wire connect to left rear stop hazard light N). dk-green wire connect to right rear stop/hazard light P) white wire connect to stop light swirch output

The turn signal flasher is above the emergency brake petal and about 6 inches above, hid by a wiring harness. It is in a clip so pull it out and leave the wire hang to replace the new flasher. If you locate the fuse box drop it down by releasing the two metal clips left and right , the flasher will be directly above the left side of the panel.

the flasher switch is defective you have to remove the stering wheel to take it off pierre

your turn sig switch in the steering column is probably worn out and needs to be replaced, have a steering column specialist come out and fix or go to the dealer.